Toyota Tacoma (2015-2018) Service Manual: Brake

Installation

INSTALLATION PROCEDURE 1. INSTALL NO. 1 ULTRASONIC SENSOR HINT: Use the same procedure for both sides. (a) Engage the 4 claws to install the 4 No. 1 ultrasonic sensors as shown in the illustrat ...

Brake Booster

...

Other materials:

Transmission Fluid Temperature Sensor "A" Circuit Low Input (P0712,P0713)
DESCRIPTION The No. 1 ATF temperature sensor converts the fluid temperature into a resistance value for use by the ECM. The ECM applies a voltage to the temperature sensor through terminal THO1 of the ECM. The sensor resistance changes with the ATF temperature. As the temperature becomes hi ...

Zero Point Calibration of Yaw Rate Sensor Undone (C1210,C1336)
DESCRIPTION The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system. The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. If th ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT AXLE HUB OIL SEAL (a) Using a brass bar and a hammer, install a new front axle hub oil seal. NOTICE: Do not damage the oil seal. 2. INSTALL FRONT AXLE WITH ABS ROTOR BEARING ASSEMBLY (a) Using SST and a press, install a new bearing onto the front axle ...