Installation
INSTALLATION
PROCEDURE
1. INSTALL BRAKE PEDAL PAD
(a) Install the brake pedal pad onto the brake pedal.
2. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY
(a) Install the brake pedal support assembly with ...
Precaution
PRECAUTION
1. Necessary care must be taken to replace each part properly as it could affect
the brake system performance. This could cause driving hazards. Replace each part
with an identical par ...
Related Tacoma materials
Front Radar Sensor Incorrect Axial Gap (C1A11)
DESCRIPTION
When the vehicle is determined to be driving in a straight line or on a gradual
curve based on signals from the yaw rate sensor, etc., the millimeter wave radar
sensor assembly performs self diagnosis to check if the sensor beam axis has deviated.
If the millimeter wave radar sens ...
Diagnosis System
DIAGNOSIS SYSTEM
1. CHECK DLC3
(a) Check the DLC3 (See page ).
2. INSPECT BATTERY VOLTAGE
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery.
3. SELF-DIAGNOSTIC MODE (OPERATING IGNITION KEY CYLINDER)
(a) Switch to se ...
Toyota Safety Sense 3.0 Software Updates
Use of these functions requires an active connected services contract provided by Toyota. Availability and access depend on the applicable service agreement. For additional information about connected services for the Toyota Tacoma, contact your Toyota dealer.
WARNING
For safe use
After the Toyota S ...