Toyota Tacoma (2015-2018) Service Manual: Can Communication System
- Parts Location
- Precaution
- System Diagram
- Problem Symptoms Table
- System Description
- Utility
- Dtc Combination Table
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Dtc Check / Clear
- Fail-safe Chart
- ECU Malfunction (B1003)
- Clearance Warning ECU Communication Stop Mode
- Air Conditioning Amplifier Communication Stop Mode
- ECM Communication Stop Mode
- Main Body ECU Communication Stop Mode
- Steering Angle Sensor Communication Stop Mode
- Center Airbag Sensor Communication Stop Mode
- Certification ECU Communication Stop Mode
- Combination Meter ECU Communication Stop Mode
- 4WD Control ECU Communication Stop Mode
- Blind Spot Monitor Sensor Communication Stop Mode
- Radio Receiver Assembly Communication Stop Mode
- Central Gateway ECU Communication Stop Mode
- Millimeter Wave Radar Sensor Communication Stop Mode
- Navigation Receiver Assembly Communication Stop Mode
- Open in Bus 2 Main Bus Line
- Check Bus 2 Line for Short to +B
- Check Bus 2 Lines for Short Circuit
- Open in Bus 3 Main Bus Line
- Open in One Side of Bus 2 Branch Line
- Check Bus 3 Line for Short to +B
- Check Bus 3 Lines for Short Circuit
- Check Bus 3 Line for Short to GND
- Open in Bus 5 Main Bus Line
- Open in One Side of Bus 3 Branch Line
- Check Bus 5 Lines for Short Circuit
- Check Bus 5 Line for Short to +B
- Check Bus 5 Line for Short to GND
- Open in One Side of Bus 5 Branch Line
- Front Camera Module Communication Stop Mode
- Tire Pressure Monitor ECU Communication Stop Mode
Parts Location
PARTS LOCATION
ILLUSTRATION
*A
for Hydraulic Brake Booster
*B
for Vacuum Brake Booster
*C
w/ Toyota Safety Sense P
...
Other materials:
Pressure Control Solenoid "C" Actuator Stuck Off (P07957F)
SYSTEM DESCRIPTION
The ECM uses the vehicle speed signal and signals from the transmission revolution
sensors (NT, SP2) to detect the actual gear (1st, 2nd, 3rd, 4th, 5th or 6th gear).
The ECM compares the actual gear with the shift schedule in the ECM memory to
detect mechanical problems of t ...
Sleep Operation Failure of Occupant Classification ECU (B1796)
DESCRIPTION
During sleep mode, the occupant detection ECU monitors the condition of each
sensor while the ignition switch is off. In this mode, if the occupant detection
ECU detects an internal malfunction, DTC B1796 is set.
DTC No.
DTC Detections Conditions
Tr ...
Steering Angle Sensor (C1A47)
DESCRIPTION
The millimeter wave radar sensor assembly receives steering angle information
from the steering angle sensor (spiral cable with sensor sub-assembly). If the millimeter
wave radar sensor assembly detects a steering angle sensor (spiral cable with sensor
sub-assembly) malfunction, D ...
