Toyota Tacoma (2015-2018) Service Manual: Diagnostic Trouble Code Chart

Data List / Active Test

DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether ...

Dtc Check / Clear

DTC CHECK / CLEAR CHECK FOR DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Central Ga ...

Other materials:

Neutral Position Switch Circuit
DESCRIPTION The ECM uses the neutral position switch installed to the manual transmission assembly to detect when the transmission is in the neutral position. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM (NEUTRAL SWITCH) (a) Connect the Techstream ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE REAR AXLE SHAFT SNAP RING (a) Using a snap ring expander, remove the snap ring. 2. REMOVE REAR AXLE SHAFT (a) Using SST and press, remove the rear axle shaft. SST: 09521-25011 SST: 09521-25021 3. REMOVE REAR AXLE BEARING RETAINER INNER (a) Remove the rear ...

Abnormal Change in Output Signal of Rear Speed Sensor RH (Test Mode DTC) (C1277,...,C1416)
DESCRIPTION Refer to DTCs C1401 and C1402 (See page ). DTC Code DTC Detection Condition Trouble Area C1277 C1278 Stored only during test mode. Rear speed sensor RH/LH Rear speed sensor rotor RH/LH (Rear ax ...