Toyota Tacoma (2015-2018) Service Manual: Brake Control / Dynamic Control Systems
Toyota Tacoma (2015-2018) Service Manual / Brake Control / Dynamic Control Systems
- Brake Actuator
- Crawl Switch
- Front Speed Sensor
- Multi-terrain Select Switch
- Rear Speed Sensor
- Steering Angle Sensor
- Traction Off Switch
- Vehicle Stability Control System(for Hydraulic Brake Booster)
- Parts Location
- Precaution
- How To Proceed With Troubleshooting
- System Description
- System Diagram
- Check For Intermittent Problems
- Calibration
- Problem Symptoms Table
- Test Mode Procedure
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Fail-safe Chart
- Freeze Frame Data
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Vehicle Control History
- ABS Control System Malfunction (43)
- Control Module Communication Bus OFF (U0073,U0100,U0114,U0123,U0124,U0126)
- Zero Point Calibration of Yaw Rate Sensor Undone (C1210,C1336)
- SM Solenoid Circuit (C1225-C1228,C1468,C1469,C146A,C146B)
- Acceleration Sensor Stuck Malfunction (C1232,C1243,C1245,C1279)
- Low Power Supply Voltage Malfunction (C1241)
- Open Circuit in IG1/IG2 Power Source Circuit (C1242)
- Open in Pump Motor Circuit (C1251)
- Brake Booster Pump Motor on Time Abnormally Long (C1252)
- Pump Motor Relay (C1253)
- Pressure Sensor or Switch (C1254)
- Accumulator Low Pressure (C1256)
- Power Supply Drive Circuit (C1257)
- Transfer L4 Position Switch Circuit (C1268)
- Low Output Signal of Front Speed Sensor RH (Test Mode DTC) (C1271,C1272,C1401,C1402)
- Low Output Signal of Rear Speed Sensor RH (Test Mode DTC) (C1273,C1274,C1403,C1404)
- Abnormal Change in Output Signal of Front Speed Sensor RH (Test Mode DTC) (C1275,...,C1414)
- Abnormal Change in Output Signal of Rear Speed Sensor RH (Test Mode DTC) (C1277,...,C1416)
- Open in ABS Solenoid Relay Circuit (C146E,C146F)
- ECM Communication Circuit Malfunction (C1203)
- Center Differential Lock Position Switch (C1282)
- Steering Angle Sensor Zero Point Malfunction (C1290)
- Diameter of the Tire is not Uniform (C1337)
- Downhill Assist Control Switch Malfunction (Test Mode DTC) (C1379)
- Acceleration Sensor Power Supply Voltage Malfunction (C1381)
- Open or Short in Front Speed Sensor RH Circuit (C1405,C1406)
- Open or Short in Rear Speed Sensor RH Circuit (C1407,C1408)
- Front Speed Sensor RH Performance (C1409,C1410)
- Rear Speed Sensor RH Performance (C1411,C1412)
- High Power Supply Voltage Malfunction (C1417)
- Acceleration Sensor Internal Circuit (C1419,C1435)
- Acceleration Sensor Malfunction (C1420)
- Open in Stop Light Switch Circuit (C1425)
- Steering Angle Sensor Power Source Voltage Malfunction (C1432)
- Steering Angle Sensor Internal Circuit (C1433)
- Steering Angle Sensor Output Malfunction (C1434)
- Yaw Rate Sensor Malfunction (C1436)
- Lost Communication with ECM (C1437)
- Steering Angle Sensor Initialization Incomplete (C1439,C1445)
- Steering Angle Sensor Unusual Bank Angle Detected (C1440)
- Invalid Data Received from Deceleration Sensor (C1442,C1443)
- Accumulator Low Pressure (C1452)
- Master Cylinder Pressure Sensor Output Malfunction (Test Mode DTC) (C1281,...,C1458)
- Master Cylinder Pressure Sensor Zero Point High Malfunction (C1422,C1456)
- Reservoir Level Switch Disconnected (C1453,C1454)
- ABS Warning Light does not Come ON
- ABS Warning Light Remains ON
- Crawl Indicator Light does not Come ON
- Crawl Indicator Light Remains ON
- Multi-terrain Select Indicator Light does not Come ON
- Multi-terrain Select Indicator Light Remains ON
- Brake Warning Light does not Come ON
- Brake Warning Light Remains ON
- TRAC OFF Indicator Light does not Come ON
- TRAC OFF Indicator Light Remains ON
- VSC OFF Indicator Light Remains ON
- Slip Indicator Light Remains ON
- VSC OFF Indicator Light does not Come ON
- AUTO LSD Indicator Light does not Come ON
- AUTO LSD Indicator Light Remains ON
- Slip Indicator Light does not Come ON
- A-TRAC Indicator Light does not Come ON
- A-TRAC Indicator Light Remains ON
- VSC Buzzer Circuit
- Vehicle Stability Control System(for Vacuum Brake Booster)
- Parts Location
- Precaution
- System Description
- System Diagram
- Check For Intermittent Problems
- How To Proceed With Troubleshooting
- Calibration
- Test Mode Procedure
- Problem Symptoms Table
- Diagnosis System
- Terminals Of Ecu
- Dtc Check / Clear
- Fail-safe Chart
- Freeze Frame Data
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Low Power Supply Voltage Malfunction (C1241)
- Vehicle Control History
- Transfer L4 Position Switch Circuit (C1268)
- Steering Angle Sensor Zero Point Malfunction (C1290)
- Diameter of the Tire is not Uniform (C1337)
- Stop Light Control Relay Malfunction (C1380)
- Acceleration Sensor Power Supply Voltage Malfunction (C1381)
- Front Speed Sensor RH Malfunction (C1401,C1402)
- Rear Speed Sensor RH Malfunction (C1403,C1404)
- Open or Short in Front Speed Sensor RH Circuit (C1405,C1406)
- Open or Short in Rear Speed Sensor RH Circuit (C1407,C1408)
- Front Speed Sensor RH Output Malfunction (C1413,C1414)
- Rear Speed Sensor RH Output Malfunction (C1415,C1416)
- High Power Supply Voltage Malfunction (C1417)
- Acceleration Sensor Internal Circuit (C1419,C1435)
- Open or Short in Master Cylinder Pressure Sensor (C1421,C1423,C1424,C142A,C1449)
- Master Cylinder Pressure Sensor Zero Point High Malfunction (C1422)
- Open in Stop Light Switch Circuit (C1425)
- Stop Light Switch OFF Stuck Malfunction (C1426)
- Motor Malfunction (C1427)
- Motor Power Supply Voltage Circuit (C142B-C146D)
- Motor Circuit Malfunction (C1428)
- Steering Angle Sensor Power Source Voltage Malfunction (C1432)
- Steering Angle Sensor Internal Circuit (C1433)
- Steering Angle Sensor Output Malfunction (C1434)
- Yaw Rate Sensor Malfunction (C1436)
- Lost Communication with ECM (C1437)
- Steering Angle Sensor Initialization Incomplete (C1439,C1445)
- Unusual Bank Angle Detected (C1440)
- Open in ABS Solenoid Relay Circuit (C146E,C146F)
- Invalid Data Received from Deceleration Sensor (C1442,C1443)
- Acceleration Sensor Stuck Malfunction (C1232,C1243,C1245)
- Control Module Communication Bus OFF (U0073,U0100,U0124,U0126)
- IG Supply Voltage Low (C120B)
- Zero Point Calibration of Yaw Rate Sensor Undone (C1210,C1336)
- SM Solenoid Circuit (C1225,C1468,C1469,C146A,C146B)
- Engine Control System Malfunction (C1201)
- ECM Communication Circuit Malfunction (C1203)
- ABS Warning Light does not Come ON
- ABS Warning Light Remains ON
- Brake Warning Light Remains ON
- Brake Warning Light does not Come ON
- Slip Indicator Light Remains ON
- AUTO LSD Indicator Light does not Come ON
- AUTO LSD Indicator Light Remains ON
- Slip Indicator Light does not Come ON
- TC and CG Terminal Circuit
- VSC Buzzer Circuit
- TS and CG Terminal Circuit
- VSC OFF Switch Circuit
- Vsc Off Switch
Vacuum Warning Switch
Components
COMPONENTS
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT BRAKE FLUID LEVEL IN RESERVOIR
2. INSPECT BRAKE BOOSTER ASSEMBLY
3. INSPECT VACUUM ...
Brake Actuator
...
Other materials:
Installation
INSTALLATION
PROCEDURE
1. INSTALL OCCUPANT DETECTION ECU
(a) Check that the ignition switch is OFF.
(b) Check that the cable is disconnected from the battery negative (-) terminal
is disconnected.
CAUTION:
After removing the cable from the terminal, wait for at least 90 seconds before
star ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Perform "Inspection After Repairs" after replacing the fuel injector assembly
(See page ).
PROCEDURE
1. INSTALL FUEL INJECTOR ASSEMBLY
HINT:
Perform "Inspection After Repairs" after replacing the fuel injector assembly
(See p ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL CHARCOAL CANISTER LEAK DETECTION PUMP SUB-ASSEMBLY
(a) Engage the 2 claws to install a new charcoal canister leak detection
pump sub-assembly to the charcoal canister assembly.
NOTICE:
Do not allow foreign matter such as grease, ...
В© 2011-2025 Copyright www.ttguide.net
