TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Brake Control / Dynamic Control Systems / Vehicle Stability Control System(for Hydraulic Brake Booster) / Rear Speed Sensor RH Performance (C1411,C1412)

Toyota Tacoma (2015-2018) Service Manual: Rear Speed Sensor RH Performance (C1411,C1412)

DESCRIPTION

Refer to DTCs C1401 and C1402 (See page ).

DTC Code

DTC Detection Condition

Trouble Area

C1411

C1412

One of the following conditions is met:

  1. When the vehicle is driven in reverse at a speed of 3 km/h (2 mph) or more and 3 of the wheel sensors detect the reverse signal, the other sensor detects a high frequency pulse 75 times while the ignition switch is ON.
  2. At a vehicle speed of 10 km/h (6 mph) or more, the vehicle speed sensor output drops by 50% for 5 seconds.
  3. The lowest wheel speed is 10 km/h (6 mph) or more and the difference between the highest and lowest wheel speed values is 2 km/h (1 mph) or less for 15 seconds.
  4. At a vehicle speed of 30 km/h (19 mph) or more, one wheel direction is different from the other 3 wheels for 1 second.
  5. At a vehicle speed of 100 km/h (62 mph), a reverse signal is output for 1 second or more.
  6. At a vehicle speed of 30 km/h (19 mph) or more, the rotation direction of one of the wheels is not detected normally and the rotation direction of the other 3 wheels is not the same for 1 second.

Rear speed sensor RH/LH

HINT:

  • DTC C1411 is for the rear speed sensor RH.
  • DTC C1412 is for the rear speed sensor LH.

CAUTION / NOTICE / HINT

NOTICE:

Check the speed sensor signal after replacement (See page PROCEDURE PROCEDURE ).

PROCEDURE

1.

REPLACE REAR SPEED SENSOR

(a) Replace the rear speed sensor (See page ). ).

NEXT

END

    Related Tacoma materials

    Voice Recognition Microphone Disconnected (B1579)
    DESCRIPTION The radio and display receiver assembly and telephone microphone assembly are connected to each other using the microphone connection detection signal lines. This DTC is stored when a microphone connection detection signal line is disconnected. DTC Code DTC Det ...

    Data Signal Circuit between Radio Receiver and Extension Module
    DESCRIPTION The stereo component tuner assembly sends the image data signal to the radio and display receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1. CHECK NO. 1 NAVIGATION WIRE ...

    Removal
    REMOVAL PROCEDURE 1. REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Off Road Package) 2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 3. DRAIN ENGINE COOLANT 4. REMOVE RADIATOR GRILLE (See page ...