TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Brake Control / Dynamic Control Systems / Vehicle Stability Control System(for Hydraulic Brake Booster) / Front Speed Sensor RH Performance (C1409,C1410)

Toyota Tacoma (2015-2018) Service Manual: Front Speed Sensor RH Performance (C1409,C1410)

DESCRIPTION

Refer to DTCs C1401 and C1402 (See page ).

DTC Code

DTC Detection Condition

Trouble Area

C1409

C1410

One of the following conditions is met:

  1. When the vehicle is driven in reverse at a speed of 3 km/h (2 mph) or more and 3 of the wheel sensors detect the reverse signal, the other sensor detects a high frequency pulse 75 times while the ignition switch is ON.
  2. At a vehicle speed of 10 km/h (6 mph) or more, the vehicle speed sensor output drops by 50% for 5 seconds.
  3. The lowest wheel speed is 10 km/h (6 mph) or more and the difference between the highest and lowest wheel speed values is 2 km/h (1 mph) or less for 15 seconds.
  4. At a vehicle speed of 30 km/h (19 mph) or more, one wheel direction is different from the other 3 wheels for 1 second.
  5. At a vehicle speed of 100 km/h (62 mph), a reverse signal is output for 1 second or more.
  6. At a vehicle speed of 30 km/h (19 mph) or more, the rotation direction of one of the wheels is not detected normally and the rotation direction of the other 3 wheels is not the same for 1 second.

Front speed sensor RH/LH

HINT:

  • DTC C1409 is for the front speed sensor RH.
  • DTC C1410 is for the front speed sensor LH.

CAUTION / NOTICE / HINT

NOTICE:

Check the speed sensor signal after replacement (See page PROCEDURE PROCEDURE ).

PROCEDURE

1.

REPLACE FRONT SPEED SENSOR

(a) Replace the front speed sensor (See page ). ).

NEXT

END

    Related Tacoma materials

    Fuel information
    Your vehicle must use only unleaded gasoline. Select octane rating 87 (Research Octane Number 91) or higher. Use of unleaded gasoline with an octane rating lower than 87 may result in engine knocking. Persistent knocking can lead to engine damage. At minimum, the gasoline you use should meet t ...

    Open in Outer Mirror Indicator(Slave) (C1AB5)
    DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects an open in the blind spot monitor indicator RH. DTC Code DTC Detection Condition Trouble Area C1AB5 ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR (a) Check that the ignition switch is off. (b) Check that the battery negative (-) terminal is disconnected. ...