Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE MULTI-TERRAIN SELECT SWITCH (DRIVE MONITOR SWITCH)
|
(a) Disengage the 2 claws to remove the multi-terrain select switch (drive monitor switch). |
|
.png)
Inspection
INSPECTION
PROCEDURE
1. INSPECT MULTI-TERRAIN SELECT SWITCH (DRIVE MONITOR SWITCH)
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Text in Illustration
|
*1 |
Multi-terrain Select Switch |
|
*a |
MUD and SAND |
|
*b |
LOOSE ROCK |
|
*c |
MOGUL |
|
*d |
ROCK and DIRT |
|
*e |
ROCK |
Text in Illustration
|
*a |
Component without harness connected (Multi-terrain Select Switch (Drive Monitor Switch)) |
Standard Resistance:
|
Tester Connection |
Switch Condition |
Specified Condition |
|---|---|---|
|
7 (ECU) - 8 (E) |
MUD and SAND |
Below 1 Ω |
|
2 (UP) - 8 (E) |
||
|
6 (DN) - 8 (E) |
10 kΩ or higher |
|
|
7 (ECU) - 8 (E) |
LOOSE ROCK |
Below 1 Ω |
|
2 (UP) - 8 (E) |
10 kΩ or higher |
|
|
6 (DN) - 8 (E) |
||
|
7 (ECU) -8 (E) |
MOGUL |
10 kΩ or higher |
|
2 (UP) -8 (E) |
||
|
6 (DN) -8 (E) |
||
|
7 (ECU) - 8 (E) |
ROCK and DIRT |
10 kΩ or higher |
|
2 (UP) - 8 (E) |
||
|
6 (DN) - 8 (E) |
Below 1 Ω |
|
|
7 (ECU) - 8 (E) |
ROCK |
10 kΩ or higher |
|
2 (UP) - 8 (E) |
Below 1 Ω |
|
|
6 (DN) - 8 (E) |
||
|
1 (SWl1) - 8 (E) |
ON/OFF: Pressed |
Below 1 Ω |
|
ON/OFF: Not pressed |
10 kΩ or higher |
If the result is not as specified, replace the multi-terrain select switch (drive monitor switch).
Installation
INSTALLATION
PROCEDURE
1. INSTALL MULTI-TERRAIN SELECT SWITCH (DRIVE MONITOR SWITCH)
(a) Engage the 2 claws to install the multi-terrain select switch (drive monitor switch).
