TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Brake Control / Dynamic Control Systems / Vsc Off Switch

Toyota Tacoma (2015-2018) Service Manual: Vsc Off Switch

Components

COMPONENTS

ILLUSTRATION

Inspection

Inspection

INSPECTION

PROCEDURE

1. INSPECT VSC OFF SWITCH

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Text in Illustration

*a

Component without harness connected

(VSC Off Switch)

*b

No Pin

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

6 - 9

Pressed

Below 1 Ω

Not pressed

10 kΩ or higher

If the value is not as specified, replace the VSC off switch.

Removal

REMOVAL

PROCEDURE

1. REMOVE ROOF CONSOLE BOX ASSEMBLY

(See page 2. REMOVE VSC OFF SWITCH )

2. REMOVE VSC OFF SWITCH

(a) Disconnect the VSC off switch connector.

(b) Disengage the 2 claws and remove the VSC off switch from the roof console box assembly.

Installation

INSTALLATION

PROCEDURE

1. INSTALL VSC OFF SWITCH

(a) Engage the 2 claws to install the VSC off switch into the roof console box assembly.

(b) Connect the VSC off switch connector.

2. INSTALL ROOF CONSOLE BOX ASSEMBLY

(See page Parking Brake )

    Related Tacoma materials

    Components
    COMPONENTS ILLUSTRATION *A for Type A *B for Type B *C for Type C - - *1 MILLIMETER WAVE RADAR SENSOR ASSEMBLY *2 MILLIMETER WAVE RADAR WIRE ...

    Short to +B in Outer Mirror Indicator(Master) (C1AB0)
    DESCRIPTION This DTC is stored when the blind spot monitor sensor LH detects a +B short in the blind spot monitor indicator LH. DTC Code DTC Detection Condition Trouble Area C1AB0 With the blind spot monitor main switch assembly (warni ...

    Vehicle Speed Signal Malfunction (B2282,B2283)
    DESCRIPTION DTC B2282 is stored when the vehicle speed signal sent by the combination meter assembly via direct line and the vehicle speed signal sent via CAN communication do not match. DTC B2283 is stored when a malfunction in the vehicle speed sensor is detected. HINT: When the cable is d ...