TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Brake Control / Dynamic Control Systems / Vehicle Stability Control System(for Hydraulic Brake Booster) / Center Differential Lock Position Switch (C1282)

Toyota Tacoma (2015-2018) Service Manual: Center Differential Lock Position Switch (C1282)

DESCRIPTION

DTC C1282 is stored only in test mode.

DTC Code

DTC Detection Condition

Trouble Area

C1282

Stored during test mode.
  • Harness or connector
  • Transfer system
  • Skid control ECU (master cylinder solenoid)

WIRING DIAGRAM

CAUTION / NOTICE / HINT

CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (master cylinder solenoid), perform calibration (See page PROCEDURE PROCEDURE ).

PROCEDURE

1.

INSPECT SKID CONTROL ECU (EXI4)

(a) Disconnect the S1 skid control ECU (master cylinder solenoid) connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Switch Condition

Specified Condition

S1-29 (EXI4) - Body ground
  • Ignition switch ON
  • Transfer 2WD position

11 to 14 V
  • Ignition switch ON
  • Transfer 4WD position

Below 1.5 V
Text in Illustration

*a

Front view of wire harness connector

(to Skid Control ECU (Master Cylinder Solenoid))
NG

GO TO STEP 3

OK

2.

CHECK TEST MODE DTC

(a) Switch the vehicle to test mode, perform the 4WD detection switch signal check, and then check that DTC C1282 is cleared (See page Result Result ).

Result

Result

Proceed to

DTC is not cleared

A

DTC is cleared

B
A

REPLACE MASTER CYLINDER SOLENOID

B

USE SIMULATION METHOD TO CHECK

3.

CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - 4 WHEEL DRIVE CONTROL ECU AND A.D.D. POSITION SWITCH)

(a) Disconnect the S1 skid control ECU (master cylinder solenoid) connector.

(b) Disconnect the F13 4 wheel drive control ECU connector.

(c) Disconnect the A3 A.D.D. position switch (differential vacuum actuator assembly) connector.

(d) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

S1-29 (EXI4) - F13-2 (ADD)

Always

Below 1 Ω

S1-29 (EXI4) - A3-3 (ADD)

Always

Below 1 Ω

S1-29 (EXI4) - Body ground

Always

10 kΩ or higher
OK

GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR
    Related Tacoma materials

    Lane Tracing Assist (LTA): Operation and Settings
    LTA functions When driving on a road with clearly visible lane markings while dynamic radar cruise control is operating, the LTA system uses the front camera and radar sensor to recognize the lane lines as well as preceding and surrounding vehicles. Based on this information, steering assistance i ...

    Riding Safely with Children
    Observe the following precautions whenever children are traveling in the vehicle. Proper supervision and correct use of the available safety equipment are essential for protecting younger passengers. Use a child restraint system that is appropriate for the child's size and needs until the child bec ...

    Precaution
    PRECAUTION 1. IGNITION SWITCH EXPRESSIONS (a) The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ignition Switch (Position) Engine ...