DESCRIPTION
The skid control ECU (master cylinder solenoid) measures the speed of each wheel by receiving signals from the speed sensors. These signals are used for recognizing whether all 4 wheels are operating properly. Therefore, all wheel signals must be equal.
|
DTC No. |
DTC Detecting Condition |
Trouble Areas |
|---|---|---|
|
C1337 |
When either one of following condition detected:
|
|
CAUTION / NOTICE / HINT
NOTICE:
Check the speed sensor signal after replacement (See page
.gif)
).
PROCEDURE
|
1. |
CHECK TIRE SIZE |
(a) Check tire size and condition of all 4 wheels.
OK:
All 4 wheels are the same size and in the same condition.
| NG | .gif) |
REPLACE TIRES SO THAT ALL 4 TIRES ARE SAME IN SIZE |
|
.gif)
|
2. |
CHECK SPEED SENSOR ROTOR |
(a) Remove the drive shaft, and check around the speed sensor rotor.
OK:
No scratches or foreign matter on the sensor tip.
| NG | |
REPLACE SPEED SENSOR ROTOR |
|
|
3. |
CHECK SPEED SENSOR |
(a) Check the speed sensor circuit.
- Front speed sensor (See page ).
- Rear speed sensor (See page ).
| NG | |
REPLACE SPEED SENSOR |
|
|
4. |
CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - EACH SPEED SENSOR) |
(a) Check the speed sensor circuit .
- Front speed sensor (See page ).
- Rear speed sensor (See page ).
| NG | |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
5. |
RECONFIRM DTC |
(a) Clear the DTCs (See page
).
(b) Drive the vehicle at more than 20 km/h (13 mph) for more than 60 seconds.
(c) Check if the same DTCs are detected.
|
Result |
Proceed to |
|---|---|
|
DTC output |
A |
|
DTC not output |
B |
| A | |
REPLACE MASTER CYLINDER SOLENOID |
| B | |
END |
