Toyota Tacoma (2015-2018) Service Manual: Seat
- Front Seat Assembly(for Driver Side)
- Front Seat Assembly(for Front Passenger Side)
- Front Seat Cushion Heater
- Front Seatback Heater
- Rear Seat Assembly(for Access Cab)
- Rear Seat Assembly(for Lh Side)
- Rear Seat Assembly(for Rh Side)
- Seat Heater System
- Parts Location
- Precaution
- System Diagram
- How To Proceed With Troubleshooting
- Operation Check
- System Description
- Dtc Check / Clear
- Problem Symptoms Table
- Terminals Of Ecu
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Front Right Seat Heat Sensor Circuit (B14C0)
- Front Left Seat Heat Sensor Circuit (B14C1)
- Driver Side Seat Heater does not Operate
- Front Passenger Side Seat Heater does not Operate
Pre-collision System Warning Buzzer
Components
COMPONENTS
ILLUSTRATION
*1
SKID CONTROL BUZZER
-
-
Inspection
INSPECTION
PROCEDURE
1. INSPECT SKID CONTROL BUZZER
...
Other materials:
Calibration
CALIBRATION
1. DESCRIPTION
(a) After replacing any VSC related components or performing wheel alignment
adjustment, clear and read the sensor calibration data.
Refer to the table below and then perform the necessary operation according to
the part to be replaced in order to perform calibratio ...
Replacement
REPLACEMENT
PROCEDURE
1. REPLACE INTAKE VALVE GUIDE BUSH
(a) Heat the cylinder head to 80 to 100°C (176 to 212°F).
(b) Place the cylinder head on wooden blocks.
(c) Using SST and a hammer, tap out the intake valve guide bushes.
SST: 09201-10000
09201-01050
SST: 09950-70010 ...
Sensor (Motor) Failure (B2341,B2344)
DESCRIPTION
When the sliding roof ECU (sliding roof drive gear sub-assembly) detects a motor
malfunction and the sliding roof operation is stopped, DTC B2341 is stored.
When the sliding roof ECU (sliding roof drive gear sub-assembly) detects a gear
position malfunction and the sliding roof ope ...
