INSTALLATION
PROCEDURE
1. INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY
HINT:
Use the same procedure for the side.
(a) Install the child restraint seat anchor bracket sub-assembly with the 2 bolts.
Torque:
30 N·m {306 kgf·cm, 22 ft·lbf}
(b) Reinstall the floor carpet.
2. INSTALL REAR SEAT HEADREST ASSEMBLY
(a) Install the 2 rear seat headrest assemblies with the 8 bolts.
Torque:
20 N·m {204 kgf·cm, 15 ft·lbf}
3. INSTALL NO. 3 ROOM PARTITION COVER
4. INSTALL NO. 4 ROOM PARTITION COVER LH
5. INSTALL NO. 4 ROOM PARTITION COVER RH
6. INSTALL BACK PANEL TRIM
7. INSTALL BACK PANEL GARNISH HOLE PLUG
8. INSTALL REAR SEAT CUSHION ASSEMBLY
(a) Install the 2 rear seat cushion assemblies with the 6 bolts.
Torque:
30 N·m {306 kgf·cm, 22 ft·lbf}
CD Sound Skips
PROCEDURE
1.
CHECK CD
(a) Check that the CD is not deformed or cracked.
OK:
No deformation or cracks on the CD
NG
CD IS FAULTY
OK
...
Fuel Sender Open Detected (B1500)
DESCRIPTION
This DTC is output when the combination meter assembly detects a fuel sender
gauge assembly malfunction.
DTC No.
DTC Detection Condition
Trouble Area
B1500
When either of the following conditions is detected:
...
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SHOCK ABSORBER ASSEMBLY
(a) Compress and extend the shock absorber rod and check that there is no abnormal
resistance or unusual sound during operation.
If there is any abnormality, replace the front shock absorber with a new one.
NOTICE:
When disposin ...