Toyota Tacoma (2015-2018) Service Manual: Components

Rear Seat Assembly(for Rh Side)

...

Removal

REMOVAL PROCEDURE 1. REMOVE REAR SEAT CUSHION ASSEMBLY (a) Remove the 2 bolts and rear seat cushion assembly. 2. REMOVE REAR SEATBACK HINGE COV ...

Other materials:

Power Source Mode does not Change to ON (ACC)
DESCRIPTION If the engine switch is pressed with the electrical key transmitter sub-assembly in the cabin, the certification ECU (smart key ECU assembly) receives a signal and changes the power source mode. HINT: When the cable is disconnected and reconnected to the negative (-) battery termi ...

Air Conditioning Compressor Magnetic Clutch Circuit
DESCRIPTION When the air conditioning amplifier assembly is turned on, a magnetic clutch on signal is sent from the MGC terminal of the air conditioning amplifier assembly. Then, the MG CLT relay turns on to operate the magnetic clutch assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NO ...

Abnormal Change in Output Signal of Rear Speed Sensor RH (Test Mode DTC) (C1277,...,C1416)
DESCRIPTION Refer to DTCs C1401 and C1402 (See page ). DTC Code DTC Detection Condition Trouble Area C1277 C1278 Stored only during test mode. Rear speed sensor RH/LH Rear speed sensor rotor RH/LH (Rear ax ...