REMOVAL
CAUTION / NOTICE / HINT
CAUTION:
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click here
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
3. REMOVE SEAT TRACK COVER
HINT:
Use the same procedures for both sides.
(a) Disengage the 2 claws to remove the seat track cover.
4. REMOVE FRONT SEAT ASSEMBLY
(a) Disengage the wire harness clamp.
(b) Disconnect the connectors.
(c) Disconnect the front seat airbag connector.
(1) Place a finger on the slider, slide the slider to release the lock, and then disconnect the front seat airbag connector.
Text in Illustration
*1 |
Slider |
- |
- |
*a |
Push |
*b |
Slide |
(d) Move the seat to the center position.
(e) Remove the 4 bolts and front seat assembly. NOTICE: Be careful not to damage the vehicle body. |
|
Purge Valve
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT PURGE VSV
(a) Measure the resistance according to the value(s) in the table below.
Text in Illustration
*a
Component without harness connected
(Purge VSV ...
Precaution
PRECAUTION
1. Check that the battery cables are connected to the correct terminals.
2. Disconnect the battery cables when the battery is given a quick charge.
3. Do not perform tests with a high voltage insulation resistance tester.
4. Never disconnect the battery while the engine is running.
5 ...
Terminals Of Ecu
TERMINALS OF ECU
CHECK MILLIMETER WAVE RADAR SENSOR ASSEMBLY
(a) Measure the voltage and resistance according to the value(s) in the table
below.
Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
...