Toyota Tacoma (2015-2018) Service Manual: Pre-collision System Warning Buzzer
Components
COMPONENTS
ILLUSTRATION
|
*1 |
SKID CONTROL BUZZER |
- |
- |
Inspection
INSPECTION
PROCEDURE
1. INSPECT SKID CONTROL BUZZER
|
(a) Make sure that there is no looseness in the locking part and connecting part of the connector. |
|
(b) Disconnect the skid control buzzer connector.
(c) Check the connector and terminals for deformation and corrosion.
OK:
No deformation or corrosion.
(d) Connect a positive (+) lead from the battery to terminal 1, and a negative (-) lead to terminal 2 of the skid control buzzer, and check that the buzzer sounds.
OK:
The skid control buzzer sounds.
If the result is not as specified, replace the skid control buzzer.
Removal
REMOVAL
PROCEDURE
1. REMOVE SKID CONTROL BUZZER
|
(a) Disengage the clamp. |
|
(b) Disconnect the connector to remove the skid control buzzer.
NOTICE:
If the skid control buzzer has been struck or dropped, replace it with a new one.
Installation
INSTALLATION
PROCEDURE
1. INSTALL SKID CONTROL BUZZER
(a) Connect the connector.
(b) Engage the clamp to install the skid control buzzer.
NOTICE:
If the skid control buzzer has been struck or dropped, replace it with a new one.
HINT:
Make sure to install the skid control buzzer in the correct direction.
ECU Power Source Circuit
DESCRIPTION
This circuit supplies power to the millimeter wave radar sensor assembly when
the ignition switch is ON.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circu ...
Seat
...
Other materials:
Transponder Key Ecu
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL TRANSPONDER KEY ECU
(a) Engage the 2 guides to move the transponder key ECU in the direction
of the arrow to install the transponder key ECU.
2. IN ...
Blower Motor Circuit
DESCRIPTION
The blower motor with fan sub-assembly operates according to signals from the
air conditioning amplifier assembly. The blower motor with fan sub-assembly speed
signals are transmitted by changes in the duty ratio.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuse ...
System Description
SYSTEM DESCRIPTION
1. LIN COMMUNICATION SYSTEM DESCRIPTION
The LIN communication system is used for communication between the components
in the tables below. If communication cannot be performed through LIN communication
because of an open in the communication lines or other reasons, the maste ...
