Toyota Tacoma (2015-2018) Service Manual: Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
NOTICE:
Do not try to remove the black nylon tube as it is welded to the fuel suction
tube assembly (See page .gif)
).
PROCEDURE
1. REMOVE FUEL SENDER GAUGE ASSEMBLY
2. REMOVE NO. 1 FUEL SUB-TANK
|
(a) Disconnect the 2 fuel pump connectors. |
|
(b) Disengage the clamp and disconnect the wire harness.
|
(c) Disengage the claw and 2 clamps and disconnect the jet pump nozzle. |
|
|
(d) Using a screwdriver with its tip wrapped with protective tape, disconnect the jet pump from the No. 1 fuel sub-tank. Text in Illustration
NOTICE: The O-ring is installed firmly between the jet pump and No. 1 fuel sub-tank. Therefore, the jet pump and No. 1 fuel sub-tank should be separated carefully using a screwdriver. |
|
|
(e) Disengage the 5 claws and remove the No. 1 fuel sub-tank. NOTICE: Do not damage the No. 1 fuel sub-tank. |
|
3. REMOVE FUEL PUMP FILTER
|
(a) Disengage the 3 claws and disconnect the fuel pump filter from the fuel filter case. |
|
|
(b) Disengage the claw and disconnect the fuel pump harness from the fuel pump filter. |
|
4. REMOVE FUEL PUMP
|
(a) Disengage the clamp and disconnect the wire harness. |
|
|
(b) Disengage the 2 claws and remove the No. 1 fuel suction support from the fuel filter case. |
|
|
(c) Remove the fuel pump from the fuel filter case. |
|
|
(d) Disconnect the fuel pump harness connector and remove the fuel pump harness from the fuel pump. |
|
|
(e) Remove the O-ring and fuel pump spacer from the fuel pump. Text in Illustration
NOTICE: Be careful not to damage the sealing surface. HINT: If the O-ring still remains in the fuel filter, remove it using a wire tip (1 mm diameter) that is formed as shown in the illustration. |
|
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
...
Removal
REMOVAL
PROCEDURE
1. REMOVE FUEL TANK ASSEMBLY
Click here
2. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Click here
3. REMOVE FUEL PUMP GAUGE RETAINER
NOTICE:
Before performing these proce ...
Other materials:
Adjustment
ADJUSTMENT
PROCEDURE
1. INSPECT AND ADJUST CLUTCH PEDAL
(a) Fold back the floor carpet.
(b) Check that the pedal height is correct.
Text in Illustration
*a
Pedal Height Adjustment Point
*b
Push Rod Pla ...
Data List / Active Test
DATA LIST / ACTIVE TEST
1. READ DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very useful because intermittent conditions or sig ...
Open or Short in Front Speed Sensor RH Circuit (C1405,C1406)
DESCRIPTION
Refer to DTCs C1401 and C1402 (See page ).
DTC Code
DTC Detection Condition
Trouble Area
C1405
C1406
Either condition is met:
An open in the speed sensor signal circuit continues for 0.5
seconds or mor ...
