INSTALLATION
PROCEDURE
1. INSTALL REAR SEATBACK CENTER HINGE SUB-ASSEMBLY
(a) Install the rear seatback center hinge sub-assembly with the 2 bolts.
Torque:
30 N·m {306 kgf·cm, 22 ft·lbf}
2. INSTALL LUGGAGE COMPARTMENT SIDE TRAY
3. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY
(a) Install the rear seatback hinge sub-assembly with the 2 bolts.
Torque:
30 N·m {306 kgf·cm, 22 ft·lbf}
4. INSTALL REAR SEATBACK ASSEMBLY LH
(a) Install the rear seatback assembly with the 2 bolts.
Torque:
37 N·m {377 kgf·cm, 27 ft·lbf}
5. INSTALL REAR SEATBACK ASSEMBLY RH
6. INSTALL REAR SEATBACK HINGE COVER
(a) for LH Side:
(1) Engage the 6 claws to install the 2 rear seatback hinge covers.
(b) for RH Side:
(1) Install the rear seatback hinge cover (See page ).
7. INSTALL REAR SEAT CUSHION ASSEMBLY
(a) Install the rear seat cushion assembly with the 2 bolts.
Torque:
37 N·m {377 kgf·cm, 27 ft·lbf}
Open / Short in Steering Lock ECU (B2781)
DESCRIPTION
The steering lock ECU and steering lock motor are built into the steering lock
actuator assembly.
The steering lock ECU (steering lock actuator or UPR bracket assembly) detects
whether the steering lock is in the lock or unlock position by using the lock sensor
and unlock sensor ...
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY (for Driver Side)
(See page )
2. REMOVE FRONT SEAT ASSEMBLY (for Front Passenger Side)
(See page )
3. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER (for Driver Side)
(See page )
4. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER (for Front Pas ...
Steering Angle Sensor (C1A47)
DESCRIPTION
The forward recognition camera receives steering angle information from the spiral
cable with sensor sub-assembly. If the forward recognition camera detects a spiral
cable with sensor sub-assembly malfunction, DTC C1A47 is stored.
DTC No.
Detection Item
...