Toyota Tacoma (2015-2018) Service Manual: Removal
REMOVAL
PROCEDURE
1. REMOVE REAR SEAT CUSHION ASSEMBLY
|
(a) Remove the 2 bolts and rear seat cushion assembly. |
|
2. REMOVE REAR SEATBACK HINGE COVER
|
(a) for LH Side: (1) Disengage the 6 claws to remove the 2 rear seatback hinge covers. |
|
(b) for RH Side:
(1) Remove the rear seatback hinge cover (See page
.gif)
).
3. REMOVE REAR SEATBACK ASSEMBLY LH
|
(a) Remove the 2 bolts and rear seatback assembly LH. |
|
4. REMOVE REAR SEATBACK ASSEMBLY RH
5. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY
|
(a) Remove the 2 bolts and rear seatback hinge sub-assembly. |
|
6. REMOVE LUGGAGE COMPARTMENT SIDE TRAY
7. REMOVE REAR SEATBACK CENTER HINGE SUB-ASSEMBLY
|
(a) Remove the 2 bolts and rear seatback center hinge sub-assembly. |
|
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
...
Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
PROCEDURE
1. REMOVE REAR SEAT CUSHION BAND
(a) Remove the screw an ...
Other materials:
Sliding Roof ECU Communication Stop (B1273)
DESCRIPTION
This DTC is stored when LIN communication between the sliding roof ECU (sliding
roof drive gear sub-assembly) and main body ECU (multiplex network body ECU) stops
for 10 seconds or more.
DTC No.
DTC Detection Condition
Trouble Area
...
Terminals Of Ecu
TERMINALS OF ECU
NOTICE:
DTCs may be output when connectors are disconnected during inspection.
Therefore, be sure to clear the DTCs using the Techstream once the inspection
has been completed.
Do not apply excessive force to the f5 forward recognition camera connector.
...
Control Module Communication Bus OFF (U0073,U0100,U0114,U0123,U0124,U0126)
DESCRIPTION
The skid control ECU (master cylinder solenoid) receives the signals from the
ECM, steering angle sensor (spiral cable with sensor sub-assembly), 4 wheel drive
control ECU*, and yaw rate and acceleration sensor (airbag sensor assembly) via
the CAN communication system.
*: ...
