Toyota Tacoma (2015-2018) Service Manual: Smart Key System(for Start Function)
Toyota Tacoma (2015-2018) Service Manual / 2gr-fks Starting / Smart Key System(for Start Function)
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- Operation Check
- System Description
- Customize Parameters
- Problem Symptoms Table
- Diagnosis System
- Dtc Check / Clear
- Terminals Of Ecu
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Runnable Signal Malfunction (B2286,P0335)
- Lost Communication with ECM / PCM (U0100,U0140,U0142,U0155,U1117)
- Brake Signal Malfunction (B2284)
- Steering Lock Position Signal Circuit Malfunction (B2285)
- Detecting Vehicle Submersion (B2277)
- Vehicle Speed Signal Malfunction (B2282,B2283)
- Ignition Hold Monitor Malfunction (B2271)
- ACC Monitor Malfunction (B2274)
- Engine does not Start
- Power Source Mode does not Change to ON (IG and ACC)
- Power Source Mode does not Change to ON (IG)
- Power Source Mode does not Change to ON (ACC)
Ignition Switch
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE LOWER STEERING COLUMN COVER
(a) Remove the 2 screws.
(b) Disengage the 2 claws and remove the lower steering colu ...
Precaution
PRECAUTION
1. CAUTION REGARDING INTERFERENCE WITH ELECTRONIC DEVICES
CAUTION:
People with implantable cardiac pacemakers, cardiac resynchronization
therapy-pacemakers or implantable car ...
Other materials:
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Rear View Monitor System
DTC Code
Detection Item
See page
C1622
Open or Short Circuit in Back Camera Signal
...
Inspection
INSPECTION
PROCEDURE
1. INSPECT PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
(a) Using a dial indicator, check the propeller shaft runout.
Maximum runout:
0.6 mm (0.0236 in.)
If the shaft runout is greater than the maximum, replace the shaft.
2. INSPECT PROPELLER SHAFT
(a) Using a dial ...
В© 2011-2026 Copyright www.ttguide.net
