Toyota Tacoma (2015-2018) Service Manual: Problem Symptoms Table

Toyota Tacoma (2015-2018) Service Manual / 2gr-fks Starting / Smart Key System(for Start Function) / Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to the system before inspecting the suspected areas below.
If the problem occurs in certain locations or times of day, the possibility of wave interference is high.
If a malfunction occurred after optional components were installed at the dealer, check if there is wave interference from the components.

Smart Key System (for Start Function)

Symptom	Suspected Area	See page
Power source mode does not change to on (IG) or on (ACC)	Refer to "Power Source Mode does not Change to ON (IG and ACC)"
Power source mode does not change to on (IG)	Refer to "Power Source Mode does not Change to ON (IG)"
Power source mode does not change to on (ACC)	Refer to "Power Source Mode does not Change to ON (ACC)"
Engine does not start	Refer to "Engine does not Start"

Customize Parameters

CUSTOMIZE PARAMETERS PROCEDURE 1. CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) HINT: The following items can be customized. NOTICE: When the customer requests a change in a function, ...

Diagnosis System

DIAGNOSIS SYSTEM 1. DESCRIPTION (a) Smart key system (for start function) data and the Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When t ...

Other materials:

Engine Control System Malfunction (C1201)
DESCRIPTION If a malfunction in the engine control system is detected, VSC and TRAC operations are prohibited by the fail-safe function. DTC No. Detection Item DTC Detection Condition Trouble Area C1201 Engine Control System ...

Vsc Off Switch
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT VSC OFF SWITCH (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Text in Illustration *a Component without h ...

Input Speed Sensor Circuit No Signal (P0717,P07BF,P07C0)
DESCRIPTION This sensor detects the rotation speed of the turbine which shows the input turbine speed of the transmission. By comparing the input turbine speed signal (NT) with the output shaft speed sensor signal (SP2), the ECM detects the shift timing of the gears and appropriately controls ...