Toyota Tacoma (2015-2018) Service Manual: Rc62f Manual Transmission / Transaxle
- Back-up Light Switch
- Counter Gear
- Input Shaft
- Manual Transmission Assembly
- Manual Transmission Oil
- Manual Transmission System
- Precaution
- Parts Location
- System Diagram
- Check For Intermittent Problems
- How To Proceed With Troubleshooting
- Problem Symptoms Table
- Diagnosis System
- Terminals Of Ecm
- Check Mode Procedure
- Data List / Active Test
- Dtc Check / Clear
- Diagnostic Trouble Code Chart
- Lost Communication With ECM/PCM "A" Missing Message (U010087)
- Crankshaft Position Sensor "A" Signal Stuck in Range (P03352A,P033531)
- Vehicle Speed Sensor "A" No Signal (P050031)
- Manual Transmission Unit
- Neutral Position Switch
- Output Shaft
Propeller Shaft System
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple
suspected areas are listed, the potential causes of the symp ...
Back-up Light Switch
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT BACK-UP LIGHT SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table be ...
Other materials:
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL
2. REMOVE REAR WHEEL
3. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER
(a) Remove the cap and valve core to release the air from the tire.
NOTICE:
Keep the removed cap and valve core.
(b) After ensuring that a sufficient amount of air has been rele ...
Parts Location
PARTS LOCATION
ILLUSTRATION
*A
for Double Cab
*B
for Access Cab
*C
w/ Back Door Power Window
-
-
*1
NO. 1 BACK PANEL PELAY
*2
NO. 2 BACK PANEL RELAY
...
Blind Spot Monitor Slave Module (C1AB7)
DESCRIPTION
This DTC is stored when the blind spot monitor sensor RH detects an internal
malfunction.
DTC Code
DTC Detection Condition
Trouble Area
C1AB7
The blind spot monitor sensor RH (slave) detects an internal malfunction.
...
