Toyota Tacoma (2015-2018) Service Manual: Lost Communication With ECM/PCM "A" Missing Message (U010087)

Toyota Tacoma (2015-2018) Service Manual / Rc62f Manual Transmission / Transaxle / Manual Transmission System / Lost Communication With ECM/PCM "A" Missing Message (U010087)

DESCRIPTION

The engine control unit and transmission control unit are located inside the ECM. The engine control unit intercommunicates with the transmission control ECU via CAN communication. If there is a problem in this intercommunication, the ECM stores this DTC.

DTC Code	DTC Detection Condition	Trouble Area	SAE
U010087	Following conditions are met for 1.25 seconds (1 trip detection logic): The ignition switch is ON Battery voltage is 9.5 V or more No communication between engine control unit and transmission control unit	ECM	U0100

CAUTION / NOTICE / HINT

HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

Check that the battery voltage is 9.5 V or more.
Turn the ignition switch to ON.
Check for DTCs again (See page ).

PROCEDURE

1.	CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC U010087)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Check if DTCs are output.

Result

Result	Proceed to
Only DTC U010087 is output	A
DTC U010087 and other DTCs are output	B

REPLACE ECM

GO TO DTC CHART

Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Manual Transmission System DTC Code Detection Item MIL Memory See page P03352A Cranks ...

Crankshaft Position Sensor "A" Signal Stuck in Range (P03352A,P033531)

DESCRIPTION The crankshaft position sensor system consists of a crankshaft position sensor plate and a pickup coil. The crankshaft position sensor plate has 34 teeth and is installed to the crank ...

Other materials:

Installation
INSTALLATION PROCEDURE 1. INSTALL PARK/NEUTRAL POSITION SWITCH HINT: Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft. (a) Clean the bolt and bolt ...

System Description
SYSTEM DESCRIPTION GENERAL The cruise control main switch is used to turn the dynamic radar cruise control system on and off, as well as operate 7 functions: SET, - (COAST), TAP-DOWN, RES (RESUME), + (ACCEL), TAP-UP and CANCEL. The SET, TAP-DOWN, and - (COAST) functions, and the RES (RESUME) ...

A-TRAC Indicator Light does not Come ON
DESCRIPTION The A-TRAC does not operate even if the A-TRAC switch is pressed under the following conditions: The TRAC or VSC system is faulty. The temperature inside the hydraulic brake booster increases and the A-TRAC operation is suspended. WIRING DIAGRAM Refer to A-TRAC ...