Toyota Tacoma (2015-2018) Service Manual: Pre-collision System
- Precaution
- Parts Location
- System Description
- System Diagram
- Customize Parameters
- How To Proceed With Troubleshooting
- Initialization
- Operation Check
- Problem Symptoms Table
- Terminals Of Ecu
- Utility
- Diagnosis System
- Dtc Check / Clear
- Freeze Frame Data
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Fail-safe Chart
- Lost Communication With Image Processing Module "A" (U023A)
- Vehicle Control History
- Heater Circuit (C1AAE)
- Lost Communication with ECM / PCM "A" (U0100,U0125,U0126,U0129)
- Lost Communication with Cruise Control Front Distance Range Sensor (U0235)
- Front Camera Module Circuit (C1AA0)
- Front Camera Module Incorrect Axial Gap (C1AA8)
- Front Camera Module Beam Axis Not Adjusted (C1AA9)
- Brake System Malfunction (C1A50)
- Other System Malfunction (C1A63)
- Brake Control Signal Mismatch (C1A69)
- Skid Control Buzzer Circuit (C1A4A)
- Stop Light Relay Circuit (C1A4B)
- Steering Angle Sensor (C1A47)
- Front Radar Sensor Incorrect Axial Gap (C1A11)
- Front Radar Sensor Beam Axis Not Adjusted (C1A14)
- Yaw Rate Sensor (C1A46)
- Vehicle Information Not Obtained (C1A02)
- Front Radar Sensor (C1A10)
- ECU Power Source Circuit
Pre-collision
...
Precaution
PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal,
initialize the following system ...
Other materials:
On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the front
airbag sensors.
PROCEDURE
1. INSPECT FRONT AIRBAG SENSOR (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check (See page
).
2. I ...
Brake Booster Pump Motor on Time Abnormally Long (C1252)
DESCRIPTION
The motor relay (semiconductor relay) is built into the master cylinder solenoid
and drives the pump motor based on a signal from the skid control ECU (master cylinder
solenoid).
DTC No.
DTC Detecting Condition
Trouble Areas
C1252
...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (w/ Intermittent function)
(a) Remove the steering column cover.
(b) Check the front wiper intermittent operation.
Text in Illustration
*a
Component with harness connected
(Windshield Wiper Sw ...
