Toyota Tacoma (2015-2018) Service Manual: On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the front airbag sensors.
PROCEDURE
1. INSPECT FRONT AIRBAG SENSOR (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check (See page
.gif)
).
2. INSPECT FRONT AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag has not Deployed)
(a) Perform a diagnostic system check (See page
).
(b) Visually check the front airbag sensors for defects if the front bumper of the vehicle or the area around the bumper is damaged.
(1) The defects are as follows:
- Cracks on the sensor housing
- Dents on the sensor housing
- Chips on the sensor housing
- Cracks or other damage to the connector
- Damage to the serial number
OK:
No defects are found.
HINT:
If any of the defects is found, replace the front airbag sensors with a new one.
3. INSPECT FRONT AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag has Deployed)
(a) When airbags have deployed as the result of a collision, be sure to replace front airbag sensors in the damaged area (anywhere in need of repair).
(b) Visually check the front airbag sensors not front collision defects.
(1) The defects are as follows:
- Cracks on the sensor housing
- Dents on the sensor housing
- Chips on the sensor housing
- Cracks or other damage to the connector
- Damage to the serial number
OK:
No defects are found.
HINT:
If any of the defects is found or a front airbag sensors has detected a major collision, replace the front airbag sensors with a new one.
Components
COMPONENTS
ILLUSTRATION
...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary
notices concerning the SRS airbag system before servicing (See ...
Other materials:
Precaution
PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following systems after the cable is reconnected.
Click here
IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch ...
Power Source Control ECU Malfunction (B2782)
DESCRIPTION
DESCRIPTION The certification ECU (smart key ECU assembly) has a power source
mode switching function.
This DTC is stored when the IGE input (the steering lock motor activation permission
signal) sent directly from the certification ECU (smart key ECU assembly) to the
steering lo ...
Portable Player cannot be Registered
CAUTION / NOTICE / HINT
HINT:
Some versions of "Bluetooth" compatible audio players may not function, or the
function may be limited using the radio and display receiver assembly, even if the
portable audio player itself can play files (See page
).
PROCEDURE
1.
...
