Toyota Tacoma (2015-2018) Service Manual: Pre-collision
- Pre-collision System
- Precaution
- Parts Location
- System Description
- System Diagram
- Customize Parameters
- How To Proceed With Troubleshooting
- Initialization
- Operation Check
- Problem Symptoms Table
- Terminals Of Ecu
- Utility
- Diagnosis System
- Dtc Check / Clear
- Freeze Frame Data
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Fail-safe Chart
- Lost Communication With Image Processing Module "A" (U023A)
- Vehicle Control History
- Heater Circuit (C1AAE)
- Lost Communication with ECM / PCM "A" (U0100,U0125,U0126,U0129)
- Lost Communication with Cruise Control Front Distance Range Sensor (U0235)
- Front Camera Module Circuit (C1AA0)
- Front Camera Module Incorrect Axial Gap (C1AA8)
- Front Camera Module Beam Axis Not Adjusted (C1AA9)
- Brake System Malfunction (C1A50)
- Other System Malfunction (C1A63)
- Brake Control Signal Mismatch (C1A69)
- Skid Control Buzzer Circuit (C1A4A)
- Stop Light Relay Circuit (C1A4B)
- Steering Angle Sensor (C1A47)
- Front Radar Sensor Incorrect Axial Gap (C1A11)
- Front Radar Sensor Beam Axis Not Adjusted (C1A14)
- Yaw Rate Sensor (C1A46)
- Vehicle Information Not Obtained (C1A02)
- Front Radar Sensor (C1A10)
- ECU Power Source Circuit
- Pre-collision System Warning Buzzer
Main Switch Illumination Circuit
DESCRIPTION
When the light control switch is turned to the tail or head position, this circuit
sends an illumination signal to the wireless charger main switch (mobile wireless
charger switch). B ...
Other materials:
Removal
REMOVAL
PROCEDURE
1. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY
(See page )
2. REMOVE TURN OVER SPRING SEAT COMPRESSION SPRING
(a) Remove the compression spring.
3. REMOVE CLUTCH PEDAL SUB-ASSEMBLY
(a) Remove the bolt and nut.
...
Crawl Indicator Light does not Come ON
DESCRIPTION
Refer to Crawl Indicator Light Remains ON (See page
).
WIRING DIAGRAM
Refer to Crawl Indicator Light Remains ON (See page
).
CAUTION / NOTICE / HINT
NOTICE:
When replacing the skid control ECU (master cylinder solenoid), perform
calibration (See page
).
Ins ...
Starting System
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs depending on the specifications
of the vehicle. The expressions listed in the table below are used in this section. ...
