Toyota Tacoma (2015-2018) Service Manual: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Pre-collision System|
DTC No. |
Detection Item |
Link |
|---|---|---|
|
C1A02 |
Vehicle Information Not Obtained |
|
|
C1A10 |
Front Radar Sensor |
|
|
C1A11 |
Front Radar Sensor Incorrect Axial Gap |
|
|
C1A14 |
Front Radar Sensor Beam Axis Not Adjusted |
|
|
C1A46 |
Yaw Rate Sensor |
|
|
C1A47 |
Steering Angle Sensor |
|
|
C1A4A |
Skid Control Buzzer Circuit |
|
|
C1A4B |
Stop Light Relay Circuit |
|
|
C1A50 |
Brake System Malfunction |
|
|
C1A63 |
Other System Malfunction |
|
|
C1A69 |
Brake Control Signal Mismatch |
|
|
C1AA0 |
Front Camera Module Circuit |
|
|
C1AA8 |
Front Camera Module Incorrect Axial Gap |
|
|
C1AA9 |
Front Camera Module Beam Axis Not Adjusted |
|
|
C1AAE |
Heater Circuit |
|
|
U0100 |
Lost Communication with ECM / PCM "A" |
|
|
U0125 |
Lost Communication with Yaw Rate Sensor Module |
|
|
U0126 |
Lost Communication with Steering Angle Sensor Module |
|
|
U0129 |
Lost Communication with Brake System Control Module |
|
|
U0235 |
Lost Communication with Cruise Control Front Distance Range Sensor |
|
|
U023A |
Lost Communication With Image Processing Module "A" |
|
|
U1002 |
Lost Communication with Gateway Module |
|
.gif)
Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference
values. Do not depend solely on these reference values when decidi ...
Fail-safe Chart
FAIL-SAFE CHART
FAIL-SAFE FUNCTION
(a) When a malfunction occurs in the pre-collision system, a message will be
displayed on the multi-information display and the pre-collision system will be
di ...
Other materials:
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Check the DTCs.
(1) Turn the ignition switch off.
(2) Connect the Techstream to the DLC3.
(3) Turn the ignition switch to ON.
(4) Turn the Techstream on.
(5) Read the DTCs following the prompts on the Techstream screen. Enter the following
menus: Powertrai ...
Pattern Select Switch Power Mode Circuit
DESCRIPTION
The ECM memory contains the programs for the normal and PWR shift patterns.
By following the programs corresponding to the signals from the pattern select
switch assembly, park/neutral position switch and other various sensors, the ECM
switches the shift solenoid valves on and off, ...
Parts Location
PARTS LOCATION
ILLUSTRATION
*1
SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)
*2
THROTTLE BODY WITH MOTOR ASSEMBLY
*3
PARK/NEUTRAL POSITION SWITCH
*4
VSC OFF SWITCH
*5
MILLIMETER ...
