Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Front Camera Module Incorrect Axial Gap (C1AA8)

Toyota Tacoma (2015-2018) Service Manual / Pre-collision / Pre-collision System / Front Camera Module Incorrect Axial Gap (C1AA8)

DESCRIPTION

If the millimeter wave radar sensor assembly detects that the beam axis of the forward recognition camera is misaligned, it will store DTC C1AA8.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AA8

Front Camera Module Incorrect Axial Gap

The millimeter wave radar sensor assembly continuously receives a signal indicating that the beam axis of the forward recognition camera is misaligned for 1 second or more.

Forward recognition camera system

PROCEDURE

1.

GO TO FORWARD RECOGNITION CAMERA SYSTEM

HINT:

If DTC C1AA8 is output by the pre-collision system, perform troubleshooting for the forward recognition camera system.

Click here

NEXT

END

Front Camera Module Circuit (C1AA0)
DESCRIPTION The millimeter wave radar sensor assembly receives information about the area in front of the vehicle from the forward recognition camera. If the millimeter wave radar sensor assembly ...

Front Camera Module Beam Axis Not Adjusted (C1AA9)
DESCRIPTION If forward recognition camera adjustment has not been performed or did not complete normally after the forward recognition camera was replaced with a new one, DTC C1AA9 will be stored ...

Other materials:

Vehicle load limits
Vehicle load limits include total load capacity, seating capacity, TWR (Trailer Weight Rating) and cargo capacity. ■ Total load capacity (vehicle capacity weight): Total load capacity means the combined weight of occupants, cargo and luggage. ■ Seating capacity: Regular Cab models ...

Operation Check
OPERATION CHECK 1. BLIND SPOT MONITOR BEAM AXIS INSPECTION (a) Procedure to enter Test Mode (1) Connect the Techstream to the DLC3. (2) Turn the ignition switch to ON. (3) Turn the blind spot monitor main switch assembly (warning canceling switch assembly) on. (4) Turn the Techstream on. (5 ...

Symbols used in illustrations
The symbol of a circle with a slash through it means “Do not”, “Do not do this”, or “Do not let this happen”. Arrows indicating operations Indicates the action (pushing, turning, etc.) used to operate switches and other devices. Indicates the outcome of an operation (e.g. a ...

© 2011-2024 Copyright www.ttguide.net