Toyota Tacoma (2015-2018) Service Manual: Parts Location
PARTS LOCATION
ILLUSTRATION
|
*A |
for Hydraulic Brake Booster |
*B |
for Vacuum Brake Booster |
|
*1 |
FORWARD RECOGNITION CAMERA |
*2 |
MILLIMETER WAVE RADAR SENSOR ASSEMBLY |
|
*3 |
HYDRAULIC BRAKE BOOSTER - SKID CONTROL ECU |
*4 |
BRAKE ACTUATOR ASSEMBLY - SKID CONTROL ECU |
|
*5 |
FORWARD RECOGNITION HOOD |
*6 |
MILLIMETER WAVE RADAR WIRE |
|
*7 |
ROOF CONSOLE BOX ASSEMBLY |
*8 |
VSC OFF SWITCH |
ILLUSTRATION
|
*1 |
COMBINATION METER ASSEMBLY - PCS WARNING LIGHT |
*2 |
AIRBAG SENSOR ASSEMBLY - YAW RATE SENSOR |
|
*3 |
STEERING ANGLE SENSOR (SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY) |
*4 |
STOP LIGHT SWITCH ASSEMBLY |
|
*5 |
SKID CONTROL BUZZER |
*6 |
DRIVER SIDE JUNCTION BLOCK - ECU-IG NO. 2 - IG1 NO. 2 |
|
*7 |
DLC3 |
*8 |
ECM |
Precaution
PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal,
initialize the following system ...
System Description
SYSTEM DESCRIPTION
PRE-COLLISION SYSTEM DESCRIPTION
(a) The pre-collision system uses the pre-collision warning control, pre-collision
brake assist control and pre-collision braking control to hel ...
Other materials:
Lost Communication with ECM / PCM "A" (U0100,U0104,U0122,U0125,U0126,U0129)
DESCRIPTION
The millimeter wave radar sensor assembly and ECM communicate with each sensor
and ECU via CAN communication.
If any malfunction is detected in a CAN communication circuit, one or more CAN
communication system DTCs are stored.
DTC No.
Detection Item
...
Acceleration Sensor Power Supply Voltage Malfunction (C1381)
DESCRIPTION
The skid control ECU (brake actuator assembly) receives signals from the yaw
rate and acceleration sensor (airbag sensor assembly) via the CAN communication
system.
The airbag sensor assembly has a built-in acceleration sensor and detects the
vehicle condition.
If there is troub ...
AUTO LSD Indicator Light Remains ON
DESCRIPTION
During normal mode, pressing the VSC OFF switch for a short amount of time changes
vehicle to AUTO LSD mode.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When replacing the brake actuator assembly, perform calibration (See page
).
PROCEDURE
1.
CHECK ...
