Toyota Tacoma (2015-2018) Service Manual: Front Camera Module Circuit (C1AA0)

Toyota Tacoma (2015-2018) Service Manual / Pre-collision / Pre-collision System / Front Camera Module Circuit (C1AA0)

DESCRIPTION

The millimeter wave radar sensor assembly receives information about the area in front of the vehicle from the forward recognition camera.

If the millimeter wave radar sensor assembly detects a malfunction in the forward recognition camera, it will store DTC C1AA0.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
C1AA0	Front Camera Module Circuit	While the ignition switch is ON, the forward recognition camera detects an internal malfunction for approximately 1 second or more.	Forward recognition camera system

PROCEDURE

1.	GO TO FORWARD RECOGNITION CAMERA SYSTEM

HINT:

If DTC C1AA0 is output by the pre-collision system, perform troubleshooting for the forward recognition camera system.

Click here

END

Lost Communication with Cruise Control Front Distance Range Sensor (U0235)

DESCRIPTION The millimeter wave radar sensor assembly is connected to the skid control ECU (master cylinder solenoid)*1 or skid control ECU (brake actuator assembly)*2 via CAN communication. If c ...

Front Camera Module Incorrect Axial Gap (C1AA8)

DESCRIPTION If the millimeter wave radar sensor assembly detects that the beam axis of the forward recognition camera is misaligned, it will store DTC C1AA8. DTC No. Detectio ...

Other materials:

Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY (a) Using a dial indicator, measure the inside diameter of the front oil pump body sub-assembly bushing. Maximum inside diameter: 38.138 mm (1.50 in.) If the inside diameter is more than the maximum inside d ...

Front Camera Module Circuit (C1AA0)
DESCRIPTION When an internal malfunction is detected in the forward recognition camera, DTC C1AA0 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area C1AA0 Front Camera Module Circuit 3 seconds ...

Inspection
INSPECTION PROCEDURE 1. INSPECT CENTER STOP LIGHT ASSEMBLY (for LED Type Stop Light) (a) Check the illuminates. (1) Apply battery voltage to the connector and check the light illumination condition. Text in Illustration *a Component without ...