ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (w/ Intermittent function)
(a) Remove the steering column cover.
(b) Check the front wiper intermittent operation.
Text in Illustration
*a |
Component with harness connected (Windshield Wiper Switch Assembly) |
(1) Turn the ignition switch on (IG).
(2) Turn the wiper switch to the INT position.
(3) Operate the intermittent wiper and check the voltage between terminals C12-3 (+1) and C13-4 (EW).
HINT:
Measure the voltage on the wire harness side with the connector connected.
OK:
Voltage changes as shown in the illustration.
If the result is not as specified, replace the windshield wiper switch assembly.
(c) Check the front washer operation.
Text in Illustration
*a |
Component with harness connected (Windshield Wiper Switch Assembly) |
(1) Turn the ignition switch on (IG).
(2) Turn the washer switch on and off, and check the voltage between terminals C13-7 (WF) and C13-4 (EW).
HINT:
Measure the voltage on the wire harness side with the connector connected.
OK:
Voltage changes as shown in the illustration.
(3) Install the steering column cover.
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Vehicle not Involved
in Collision)
(a) Perform a diagnostic system check (See page
).
(b) With the lower No. 1 instrument panel airbag assembly ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT CYLINDER BLOCK FOR WARPAGE
(a) Using a precision straightedge and feeler gauge, measure the warpage
of the contact surface of the cylinder head gasket.
Standard warpage:
0 to 0.05 mm (0 to 0.00197 in.)
Maximum warpage:
0.07 mm (0.00276 ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SUSPENSION LOWER ARM
(a) Flip the ball joint stud back and forth 5 times, as shown in the illustration,
before installing the nut.
(b) Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds
per turn and take the torque reading on ...