Toyota Tacoma (2015-2018) Service Manual: Cruise Control System(for 2gr-fks)
- Definition Of Terms
- Precaution
- Parts Location
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Problem Symptoms Table
- Road Test
- Diagnosis System
- Terminals Of Ecu
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Dtc Check / Clear
- Cruise Control System Internal Failure (P057504,P057549)
- Lost Communication with Vehicle Dynamics Control Module Missing Message (U012287)
- Vehicle Control History
- Brake Switch "A" Circuit Open (P057113)
- Brake System (P157800)
- Clutch Switch Circuit
- Brake Switch "A" Signal Compare Failure (P057162)
- Cruise Control Input Processor (P160700)
- Cruise Control Switch Circuit
- Cruise Main Indicator Light Circuit
- TC and CG Terminal Circuit
Cruise Control Main Switch
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE STEERING PAD ASSEMBLY
(See page )
2. REMOVE CRUISE CONTROL MAIN SWITCH
(a) Disconnect the connector a ...
Definition Of Terms
DEFINITION OF TERMS
Term
Definition
Monitor Description
Description of what the ECM monitors and how it detects malfunctions
(monitoring purpose ...
Other materials:
Interior Light Auto Cut Circuit
DESCRIPTION
When the battery saving control operates, the main body ECU (multiplex network
body ECU) controls the operation of the DOME CUT relay, that is built in to the
driver side junction block, to turn off the interior lights.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
In ...
Center Differential Lock Position Switch (C1282)
DESCRIPTION
DTC C1282 is stored only in test mode.
DTC Code
DTC Detection Condition
Trouble Area
C1282
Stored during test mode.
Harness or connector
Transfer system
Skid control ECU (master cylinder sole ...
Operation Check
OPERATION CHECK
1. CHECK WINDOW LOCK FUNCTION
(a) Turn the ignition switch ON.
(b) Press the window lock switch of the power window regulator master switch
assembly.
HINT:
The illumination (LED) built into the switch knob of each seat does not turn
off.
(c) Check that the power window fo ...
