Toyota Tacoma (2015-2018) Service Manual: Precaution
PRECAUTION
HANDLING PRECAUTION FOR CRUISE CONTROL SYSTEM
(a) Turn the cruise control system off using the cruise control main switch (ON-OFF button) when not using the cruise control system.
(b) Be careful as the vehicle speed increases when driving downhill with the cruise control system controlling vehicle speed.
(c) The + (ACCEL)/RES (RESUME) operation changes according to the cruise control system status. When the cruise control system is controlling vehicle speed, the + (ACCEL) function operates. When the cruise control system is not controlling vehicle speed, the RES (RESUME) function operates.
(d) While the cruise control system is controlling vehicle speed, if the cruise control indicator turns off and a warning message is displayed, turn the cruise control system off using the cruise control main switch (ON-OFF button) to reset the cruise control system. After the cruise control system is reset, if the cruise control system does not turn on, or if the cruise control system stops functioning immediately after being turned on, there may be a malfunction.
(e) Do not use the cruise control system where the road conditions are as follows:
- Heavy traffic
- Steep downhill roads
- Roads with sharp turns
- Icy or snowy roads
- Slippery roads
(f) Do not use the cruise control system while towing.
Definition Of Terms
DEFINITION OF TERMS
Term
Definition
Monitor Description
Description of what the ECM monitors and how it detects malfunctions
(monitoring purpose ...
Parts Location
PARTS LOCATION
ILLUSTRATION
...
Other materials:
Removal
REMOVAL
PROCEDURE
1. REMOVE RADIATOR GRILLE
(a) w/ Toyota Safety Sense P
(1) Disconnect the connector.
(2) Disengage the clamp.
(b) Put protective tape around the radiator grille.
...
ACC Monitor Malfunction (B2274)
DESCRIPTION
This DTC is stored when a malfunction in the ACC output circuit is detected.
The ACC output circuit is the circuit that goes from the ACC output terminal of
the certification ECU (smart key ECU assembly) to the ACC relay.
HINT:
When the cable is disconnected and reconnected to the ...
A-TRAC Indicator Light does not Come ON
DESCRIPTION
The A-TRAC does not operate even if the A-TRAC switch is pressed under the following
conditions:
The TRAC or VSC system is faulty.
The temperature inside the hydraulic brake booster increases and the
A-TRAC operation is suspended.
WIRING DIAGRAM
Refer to A-TRAC ...
