Toyota Tacoma (2015-2018) Service Manual: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
If a trouble code is indicated while checking DTCs, inspect the circuit listed for that code in the table below, and proceed to the applicable page.
Cruise Control System|
DTC Code |
Detection Item |
MIL |
See page |
|---|---|---|---|
|
P057113 |
Brake Switch "A" Circuit Open |
Does not come on |
|
|
P057162 |
Brake Switch "A" Signal Compare Failure |
Does not come on |
|
|
P057504 |
Cruise Control System Internal Failure |
Does not come on |
|
|
P057549 |
Cruise Control Internal Electronic Failure |
Does not come on |
|
|
P157800 |
Brake System |
Does not come on |
|
|
P160700 |
Cruise Control Input Processor |
Comes on |
|
|
U012287 |
Lost Communication with Vehicle Dynamics Control Module Missing Message |
Does not come on |
|
.gif)
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any p ...
Dtc Check / Clear
DTC CHECK / CLEAR
NOTICE:
When the diagnosis system is changed from normal mode to check mode or vice versa,
all DTCs and freeze frame data recorded in normal mode are cleared. Before changing
m ...
Other materials:
Customize Parameters
CUSTOMIZE PARAMETERS
PROCEDURE
1. CUSTOMIZE THEFT DETERRENT SYSTEM (w/ Wireless Door Lock System)
HINT:
The following items can be customized.
NOTICE:
When the customer requests a change in a function, first make sure that
the function can be customized.
Be sure to make a note ...
Dtc Check / Clear
DTC CHECK / CLEAR
NOTICE:
When the diagnosis system is changed from normal mode to check mode or vice versa,
all DTCs and freeze frame data recorded in normal mode are cleared. Before changing
modes, always check and make a note of DTCs and freeze frame data.
HINT:
DTCs which are sto ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT MAGNET STARTER SWITCH ASSEMBLY
(a) Inspect the pull-in coil.
(1) Measure the resistance according to the value(s) in the table below.
Text in Illustration
*a
Terminal 50
*b
...
