Toyota Tacoma (2015-2018) Service Manual: Interior

Low Pitched Horn

Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT LOW PITCHED HORN ASSEMBLY (a) Check the operation. (1) Apply battery voltage to the terminal 1 an ...

Front Console Box

...

Other materials:

Disassembly
DISASSEMBLY PROCEDURE 1. INSPECT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING (a) Check the spider bearings for wear and damage. (b) Check each spider bearings axial play by turning the yoke while holding the shaft tightly. Maximum bearing axial play: 0 to 0.05 mm (0 to 0.00197 in.) If t ...

Master Module Horizontal Axis Misalignment (C1AC1)
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis. HINT: If drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor ...

Ignition Hold Monitor Malfunction (B2271)
DESCRIPTION This DTC is stored when a malfunction in the IG circuit or IG hold circuit in the certification ECU (smart key ECU assembly) is detected. HINT: When the cable is disconnected and reconnected to the negative (-) battery terminal, the power source mode returns to the state it was in ...