Toyota Tacoma (2015-2018) Service Manual: Pre-collision
- Pre-collision System
- Precaution
- Parts Location
- System Description
- System Diagram
- Customize Parameters
- How To Proceed With Troubleshooting
- Initialization
- Operation Check
- Problem Symptoms Table
- Terminals Of Ecu
- Utility
- Diagnosis System
- Dtc Check / Clear
- Freeze Frame Data
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Fail-safe Chart
- Lost Communication With Image Processing Module "A" (U023A)
- Vehicle Control History
- Heater Circuit (C1AAE)
- Lost Communication with ECM / PCM "A" (U0100,U0125,U0126,U0129)
- Lost Communication with Cruise Control Front Distance Range Sensor (U0235)
- Front Camera Module Circuit (C1AA0)
- Front Camera Module Incorrect Axial Gap (C1AA8)
- Front Camera Module Beam Axis Not Adjusted (C1AA9)
- Brake System Malfunction (C1A50)
- Other System Malfunction (C1A63)
- Brake Control Signal Mismatch (C1A69)
- Skid Control Buzzer Circuit (C1A4A)
- Stop Light Relay Circuit (C1A4B)
- Steering Angle Sensor (C1A47)
- Front Radar Sensor Incorrect Axial Gap (C1A11)
- Front Radar Sensor Beam Axis Not Adjusted (C1A14)
- Yaw Rate Sensor (C1A46)
- Vehicle Information Not Obtained (C1A02)
- Front Radar Sensor (C1A10)
- ECU Power Source Circuit
- Pre-collision System Warning Buzzer
Main Switch Illumination Circuit
DESCRIPTION
When the light control switch is turned to the tail or head position, this circuit
sends an illumination signal to the wireless charger main switch (mobile wireless
charger switch). B ...
Other materials:
Diagnosis System
DIAGNOSIS SYSTEM
1. DESCRIPTION
The main body ECU (multiplex network body ECU) and certification ECU (smart key
ECU assembly) control the LIN communication system. LIN communication system data
and Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector
3 (DLC3).
When th ...
Engine Coolant Temperature Receiver Gauge Malfunction
DESCRIPTION
In this circuit, the meter CPU receives engine coolant temperature signals from
the ECM using the CAN communication system (CAN V1 Bus). The meter CPU displays
engine coolant temperature that is calculated based on the data received from the
ECM.
WIRING DIAGRAM
CAUTION / NOTIC ...
Display does not Dim when Light Control Switch is Turned ON
PROCEDURE
1.
CHECK IMAGE QUALITY SETTING
(a) Display the "Display" screen.
(b) Turn the light control switch to the tail or head position.
(c) Check if "Day Mode" on the display adjustment screen is on.
OK:
"Day Mode" setting is of ...
