Toyota Tacoma (2015-2018) Service Manual: Blind Spot Monitor System
- Precaution
- Parts Location
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Operation Check
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Freeze Frame Data
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Software Incompatibility with Body Control Module "B" (U1331)
- Lost Communication with Blind Spot Monitor Slave Module (U0232)
- Lost Communication with ECM / PCM "A" (U0100,U0126,U0129,U0142)
- Short to +B in Buzzer (C1ABD,C1ABE)
- Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)
- Destination Information Undefined (C1AB8)
- Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)
- Blind Spot Monitor Slave Module (C1AB7)
- Open in Outer Mirror Indicator(Slave) (C1AB5)
- Blind Spot Monitor Master Module (C1AB6)
- Open in Outer Mirror Indicator(Master) (C1AB4)
- Short to GND in Outer Mirror Indicator(Master) (C1AB2)
- Short to GND in Outer Mirror Indicator(Slave) (C1AB3)
- Short to +B in Outer Mirror Indicator(Slave) (C1AB1)
- Vehicle Speed Sensor (C1A45)
- Short to +B in Outer Mirror Indicator(Master) (C1AB0)
- Steering Angle Sensor (C1A47)
- Slave Module Horizontal Axis Misalignment (C1AC2)
- Master Module Horizontal Axis Misalignment (C1AC1)
- Main Switch Circuit
- Power Source Circuit
Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
Replace the blind spot monitor sensor if it has been dropped or subjected to
a severe impact.
PROCEDURE
1. INSTALL BLIND SPOT MONITOR SENSOR LH
(a) ...
Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below are u ...
Other materials:
Road Test
ROAD TEST
PROBLEM SYMPTOM CONFIRMATION
HINT:
The dynamic radar cruise control system has 2 cruise control modes:
constant speed control mode and vehicle-to-vehicle distance control mode.
Vehicle-to-vehicle distance control mode is selected by default when
the dyna ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE TELEPHONE MICROPHONE ASSEMBLY
Click here
2. REMOVE MICROPHONE CASE
(a) w/o Sliding Roof:
(1) Disengage the claw and guide to remove the microphone case.
(b) w/ Sliding Roof:
(1) Disengage th ...
Crankshaft Position Sensor "A" Signal Stuck in Range (P03352A,P033531)
DESCRIPTION
The crankshaft position sensor system consists of a crankshaft position sensor
plate and a pickup coil. The crankshaft position sensor plate has 34 teeth and is
installed to the crankshaft. The pickup coil is made of wound copper wire, an iron
core and a magnet. The crankshaft pos ...
