DESCRIPTION
This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.
HINT:
This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.
DTC Code |
DTC Detection Condition |
Trouble Area |
---|---|---|
C1ABB |
A beam axis inspection has not been performed. |
Blind spot monitor sensor LH |
PROCEDURE
1. |
PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION) |
(a) Change the blind spot monitor sensor LH to Test Mode using the Techstream.
HINT:
Refer to Blind Spot Monitor Beam Axis Inspection (See page ).
NEXT |
END |
Operation Check
OPERATION CHECK
1. CHECK SMART KEY SYSTEM (for Entry Function) OPERATION
NOTICE:
Make sure that the smart key system (for Entry Function) has not been canceled
before performing this inspection.
(a) Check the entry unlock function (driver door).
(1) Perform a wireless lock operation to lock t ...
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Door Unlock Detection Switch Circuit
DESCRIPTION
The main body ECU (multiplex network body ECU) detects the condition of each
door unlock detection switch.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
If the main body ECU (multiplex network body ECU) is replaced, refer to Registration
(See page ).*1
*1: w/ Smart K ...