DESCRIPTION
This circuit provides power to operate the blind spot monitor sensor.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1. |
CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH, BLIND SPOT MONITOR SENSOR LH - BATTERY AND BODY GROUND) |
(a) Disconnect the blind spot monitor sensor LH connector. |
|
(b) Disconnect the blind spot monitor sensor RH connector.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
B12-5 (BLB) - Body ground |
Ignition switch ON |
11 to 14 V |
B12-5 (BLB) - Body ground |
Ignition switch off |
Below 1 V |
B13-5 (BRB) - Body ground |
Ignition switch ON |
11 to 14 V |
B13-5 (BRB) - Body ground |
Ignition switch off |
Below 1 V |
(d) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
B12-10 (BLGD) - Body ground |
Always |
Below 1 Ω |
B13-10 (BRGD) - Body ground |
Always |
Below 1 Ω |
*a |
Front view of wire harness connector (to Blind Spot Monitor Sensor LH) |
*b |
Front view of wire harness connector (to Blind Spot Monitor Sensor RH) |
OK |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
Headlight switch
The headlights can be operated manually.
Turning the end of the lever turns on the lights as follows:
Type A
The daytime running lights turn
on.
The side marker, parking, tail,
license plate, daytime running lights and instrument panel lights turn on.
The headlights and all lights lis ...
Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
PROCEDURE
1. REMOVE REAR SEAT CUSHION BAND
(a) Remove the screw and rear seat cushion band.
2. REMOVE REAR SEAT HEADREST HO ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the sliding roof system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...