DESCRIPTION
This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis.
HINT:
If drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor main switch assembly (warning canceling switch assembly) on, the blind spot monitor system may store this DTC by mistake.
DTC Code |
DTC Detection Condition |
Trouble Area |
---|---|---|
C1AC1 |
When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is activated. |
Blind spot monitor sensor LH |
CAUTION / NOTICE / HINT
NOTICE:
Click here
If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.
PROCEDURE
1. |
CHECK INSTALLATION CONDITION |
(a) Check the installation condition of the blind spot monitor sensor LH (See page ).
HINT:
Take the appropriate action in accordance with the result.
|
2. |
PERFORM BEAM AXIS CONFIRMATION |
(a) Install the rear bumper.
(b) Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream (See page ).
OK:
Blind Spot Monitor Beam Axis Confirmation performs normally.
OK |
END |
NG |
REPLACE BLIND SPOT MONITOR SENSOR LH |
FCM Destination Information Uninitialized (C1AAA)
DESCRIPTION
When the forward recognition camera is replaced with a new one, the new forward
recognition camera attempts to store the country specification information received
from the main body ECU (multiplex network body ECU). If the forward recognition
camera cannot store the country speci ...
Transmission Fluid Temperature Sensor "B" Circuit Short to Ground (P274011)
DESCRIPTION
The No. 2 ATF temperature sensor is installed in the transmission valve body
assembly.
If the ECM detects an abnormally high ATF temperature near this sensor, it illuminates
the warning indicator.
HINT:
The temperature of ATF easily rises when towing, climbing hills, in
...
Engine does not Start but Initial Combustion Occurs
DESCRIPTION
If the key ID codes of the key and transponder key ECU assembly match, the engine
immobiliser system is unset and the engine start permission signal is sent to the
ECM. When the ID codes of the transponder key ECU assembly and ECM match, the engine
starts.
WIRING DIAGRAM
CAUTI ...