DIAGNOSTIC TROUBLE CODE CHART
Blind Spot Monitor System
DTC Code |
Detection Item |
See page |
---|---|---|
C1A45 |
Vehicle Speed Sensor |
|
C1A47 |
Steering Angle Sensor |
|
C1AB0 |
Short to +B in Outer Mirror Indicator(Master) |
|
C1AB1 |
Short to +B in Outer Mirror Indicator(Slave) |
|
C1AB2 |
Short to GND in Outer Mirror Indicator(Master) |
|
C1AB3 |
Short to GND in Outer Mirror Indicator(Slave) |
|
C1AB4 |
Open in Outer Mirror Indicator(Master) |
|
C1AB5 |
Open in Outer Mirror Indicator(Slave) |
|
C1AB6 |
Blind Spot Monitor Master Module |
|
C1AB7 |
Blind Spot Monitor Slave Module |
|
C1AB8 |
Destination Information Undefined |
|
C1ABB* |
Blind Spot Monitor Master Module Beam Axis Inspection Incomplete |
|
C1ABC* |
Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete |
|
C1ABD |
Short to +B in Buzzer |
|
C1ABE |
Short to GND or Open in Buzzer |
|
C1AC1 |
Master Module Horizontal Axis Misalignment |
|
C1AC2 |
Slave Module Horizontal Axis Misalignment |
|
U0100 |
Lost Communication with ECM / PCM "A" |
|
U0126 |
Lost Communication with Steering Angle Sensor Module |
|
U0129 |
Lost Communication with Brake System Control Module |
|
U0142 |
Lost Communication with Body Control Module "B" |
|
U0232 |
Lost Communication with Blind Spot Monitor Slave Module |
|
U1331 |
Software Incompatibility with Body Control Module "B" |
|
HINT:
*: Stored when a blind spot monitor sensor is replaced.
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY
(a) When there is a malfunction such as noise from a speaker or no sound at all,
replace the speaker with a new one and check that the malfunction disappears.
OK:
Malfunction disappears.
HINT:
Connect the connectors to th ...
Certification ECU Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Certification ECU Communication Stop Mode
Either condition is met:
Communication stop for "Certification (Smart)" is indicated
on the "Communication Bus Ch ...
Washer Nozzle
Components
COMPONENTS
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT WASHER NOZZLE SUB-ASSEMBLY
(a) Operate the washer nozzle sub-assembly and check the position that the washer
fluid hits the windshield.
Standard:
Washer fluid hits the windshield gla ...