DESCRIPTION
This DTC is stored when the blind spot monitor sensor RH detects an internal malfunction.
DTC Code |
DTC Detection Condition |
Trouble Area |
---|---|---|
C1AB7 |
The blind spot monitor sensor RH (slave) detects an internal malfunction. |
Blind spot monitor sensor RH |
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.
PROCEDURE
1. |
CHECK DTC |
(a) Clear the DTCs (See page ).
(b) Recheck for DTCs and check if the same DTC is output again (See page ).
OK:
No DTCs are output.
OK |
USE SIMULATION METHOD TO CHECK |
NG |
REPLACE BLIND SPOT MONITOR SENSOR RH |
If the vehicle becomes stuck
Carry out the following procedures if the tires spin or the vehicle becomes
stuck in mud, dirt, or snow.
Stop the engine. Set the parking
brake and put the shift lever in P (vehicles with an automatic transmission) or
N (vehicles with a manual transmission).
Remove the mud, snow, or sand f ...
Input Speed Sensor Circuit No Signal (P0717,P07BF,P07C0)
DESCRIPTION
This sensor detects the rotation speed of the turbine which shows the input turbine
speed of the transmission. By comparing the input turbine speed signal (NT) with
the output shaft speed sensor signal (SP2), the ECM detects the shift timing of
the gears and appropriately controls ...
Engine Coolant Temperature Sensor
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR
(a) Partially immerse the engine coolant temperature sensor in water and warm
up the water.
(b) Measure the resistance according to the value(s) in the table bel ...