TTGuideTacoma manuals & technical reference
HomeAbout carFAQReviewLatestPopularManual indexSearchContacts
Toyota Tacoma (2015-2018) Service Manual / Steering Column

Toyota Tacoma (2015-2018) Service Manual: Steering Column

  • Steering Column Assembly
    1. Components
    2. Disassembly
    3. Removal
    4. Installation
    5. Reassembly
  • Steering Lock System
    1. Precaution
    2. Parts Location
    3. System Description
    4. System Diagram
    5. How To Proceed With Troubleshooting
    6. Problem Symptoms Table
    7. Diagnosis System
    8. Dtc Check / Clear
    9. Terminals Of Ecu
    10. Data List / Active Test
    11. Diagnostic Trouble Code Chart
    12. Open / Short in Steering Lock ECU (B2781)
    13. Power Source Control ECU Malfunction (B2782)
    14. IG2 Signal Malfunction (B2788)
    15. Unable to Lock Steering Wheel
    16. Unable to Unlock Steering Wheel (Engine cannot Start)
  • Steering System
    1. Precaution
    2. On-vehicle Inspection
    3. Problem Symptoms Table
    4. Repair
← Previous articleReassemblyREASSEMBLY CAUTION / NOTICE / HINT NOTICE: When installing, coat the parts indicated by the arrows with power steering fluid (See page ). PROCEDURE 1. INST…→ Next articleSteering Column Assembly

Related Tacoma materials

If the vehicle becomes stuck
Carry out the following procedures if the tires spin or the vehicle becomes stuck in mud, dirt, or snow. Stop the engine. Set the parking brake and put the shift lever in P (vehicles with an automatic transmission) or N (vehicles with a manual transmission). ...

Low Power Supply Voltage Malfunction (C1241)
DESCRIPTION If a malfunction is detected in the power supply circuit, the skid control ECU (brake actuator assembly) stores this DTC and the fail-safe function prohibits ABS operation. This DTC is stored when the +BS terminal voltage deviates from the DTC detection condition due to a malfunc ...

TS and CG Terminal Circuit
DESCRIPTION In Test Mode (signal check), a malfunction in the speed sensor that cannot be detected when the vehicle is stopped can be detected while driving. Sensor check mode can be entered by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON. WIRING D ...

TTGuide

Toyota Tacoma manuals, maintenance guides, service procedures and technical references — organized to help you find the right information faster.

Search the manual library →

Explore

  • Manual index
  • Latest materials
  • Popular materials
  • Search manuals

Tacoma resources

  • Tacoma history
  • Tacoma review
  • Frequently asked questions

Information

  • Contact us
  • Privacy Policy
© 2011-2026 www.ttguide.net. All rights reserved. Independent reference site. Not affiliated with or endorsed by Toyota Motor Corporation. Page generated in 0.0122s