Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR
(a) Partially immerse the engine coolant temperature sensor in water and wa ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT OIL CLEARANCE
(a) Using a micrometer and caliper gauge, measure the oil seal clearance.
Standard clearance:
0.021 to 0.043 mm (0.0008 to 0.0017 in.)
Maximum clearance:
0.07 mm (0.0028 in.)
If it is greater than the maximum, replace the vane pump assembly.
...
Turn Signal Lever Operation
Operating instructions
Move the turn signal lever to indicate a right turn with the Toyota Tacoma.
For a lane change to the right, move the lever partway in the appropriate direction and then release it.The right turn signals will automatically flash 3 times to indicate the intended lane change ...
Transfer L4 Position Switch Circuit (C1268)
DESCRIPTION
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1268
Transfer L4 Position Switch Circuit
Either of the following is detected:
The skid control ECU (brake actuator assembly) dete ...
Engine Coolant Temperature Sensor
Camshaft