Toyota Tacoma (2015-2018) Service Manual: Theft Deterrent
- Engine Hood Courtesy Switch
- Security Horn Assembly
- Theft Deterrent System
- Parts Location
- Precaution
- Customize Parameters
- How To Proceed With Troubleshooting
- System Description
- System Diagram
- Diagnosis System
- Problem Symptoms Table
- Terminals Of Ecu
- Data List / Active Test
- Theft Deterrent System cannot be Set or Unset
- Theft Deterrent System is not Unset when Engine is Running
- Theft Deterrent System Unexpectedly Sets Itself
- Some Alarm Functions do not Operate
- While Alarm is Armed, Battery is Reconnected but Alarm does not Sound
- While Alarm is Armed, Engine Hood is opened but Alarm does not Sound
Installation
INSTALLATION
PROCEDURE
1. INSTALL STEERING PAD
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least ...
Engine Hood Courtesy Switch
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)
(a) Check the resistance.
(1) Measure the resistance ac ...
Other materials:
Diagnosis System
DIAGNOSIS SYSTEM
1. DESCRIPTION
(a) When troubleshooting OBD II (On-Board Diagnostics) vehicles, an OBD II scan
tool (complying with SAE J1978) must be connected to the DLC3 (Data Link Connector
3) of the vehicle. Various data in the vehicle ECM (Engine Control Module) can be
then read.
(b) ...
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR SEAT ASSEMBLY LH (for Double Cab)
Click here
2. REMOVE REAR SEAT ASSEMBLY RH (for Double Cab)
Click here
3. REMOVE REAR DOOR SCUFF PLATE LH (for Double Cab)
Click here
4. REMOVE REAR DOOR SCUFF PLATE RH (for Double Cab)
HINT:
Use the same procedure ...
Removal
REMOVAL
PROCEDURE
1. REMOVE FUEL DELIVERY PIPE ASSEMBLY LH (FUEL PRESSURE SENSOR)
(See page )
NOTICE:
Do not remove the fuel pressure sensor from the fuel delivery pipe sub-assembly
LH.
If a fuel pressure sensor is removed, replace the fuel delivery pipe
sub-assembly LH (fu ...
