Toyota Tacoma (2015-2018) Service Manual: Air Conditioning System(for Manual Air Conditioning System)
- Parts Location
- Precaution
- How To Proceed With Troubleshooting
- System Description
- System Diagram
- Problem Symptoms Table
- Diagnosis System
- Dtc Check / Clear
- Terminals Of Ecu
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Ambient Temperature Sensor Circuit (B1412)
- Pressure Sensor Circuit (B1423)
- Lost Communication with ECM (U0100,U0142,U0155)
- Air Conditioning Compressor Magnetic Clutch Circuit
- Evaporator Temperature Sensor Circuit (B1413)
- Compressor Lock Sensor Circuit (B1422)
- PTC Heater Circuit
Back-up Power Source Circuit
DESCRIPTION
The back-up power source circuit for the air conditioning amplifier assembly
is shown below. Power is supplied even when the ignition switch is off. The power
is used for diagnostic t ...
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Other materials:
Charging Failure
PROCEDURE
1.
CHECK GENERATOR PULLEY WITH CLUTCH (ON-VEHICLE INSPECTION)
(a) Start the engine and visually check if the fan of the generator rotor assembly
located inside the generator assembly is operating.
OK:
The fan of the generator rotor assembly is operati ...
Front Passenger Side Seat Belt Warning Light Malfunction
DESCRIPTION
The occupant classification ECU detects the state of the front seat inner belt
assembly RH and load sensor when the front passenger side seat is occupied with
the ignition switch ON. If the front passenger side seat belt is not fastened, the
front passenger side seat belt warning ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
Replace the blind spot monitor sensor if it has been dropped or subjected to
a severe impact.
PROCEDURE
1. INSTALL BLIND SPOT MONITOR SENSOR LH
(a) Install the blind spot monitor sensor LH with the 3 nuts.
Torque:
9.0 N·m {92 kgf·cm, 80 in·l ...
