Toyota Tacoma (2015-2018) Service Manual: Lost Communication with ECM (U0100,U0142,U0155)
DESCRIPTION
|
DTC No. |
DTC Detecting Condition |
Trouble Area |
|---|---|---|
|
U0100 |
No communication with ECM |
|
|
U0142 |
No communication with main body ECU |
|
|
U0155 |
No communication with combination meter |
|
PROCEDURE
|
1. |
GO TO CAN COMMUNICATION SYSTEM |
HINT:
Refer to CAN Communication System (See page .gif)
).
| NEXT | .gif) |
END |
Pressure Sensor Circuit (B1423)
DESCRIPTION
This DTC is stored if refrigerant pressure on the high pressure side is extremely
low (176 kPa (1.8 kgf/cm2, 26 psi) or less) or extremely high (3140 kPa (32.0 kgf/cm2,
455 psi) or mo ...
Air Conditioning Compressor Magnetic Clutch Circuit
DESCRIPTION
When the air conditioning amplifier assembly is turned on, a magnetic clutch
on signal is sent from the MGC terminal of the air conditioning amplifier assembly.
Then, the MG CLT relay ...
Other materials:
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT PARK/NEUTRAL POSITION SWITCH
(a) Apply the parking brake.
(b) Turn the ignition switch to ON.
(c) Depress the brake pedal and move the shift lever to any position other than
P.
(d) Depress the brake pedal and check that the engine starts when the sh ...
TC and CG Terminal Circuit
DESCRIPTION
DTC output mode is set by connecting terminals TC and CG of the DLC3.
The DTCs are displayed by blinking the SRS warning light.
HINT:
Make sure that DTCs which relate to the CAN communication system are
not output. If any of these DTCs are output, check the CAN communicat ...
Internal Control Module EEPROM Data Memory Failure (P062F44)
DESCRIPTION
The ECM monitors its internal operation and it will set this DTC when it detects
an internal malfunction.
DTC No.
DTC Detection Condition
Trouble Area
SAE
P062F44
ECM internal error (EEPROM)
ECM
...
