Toyota Tacoma (2015-2018) Service Manual: Smart Key System(for Entry Function)
- Parts Location
- Precaution
- System Diagram
- How To Proceed With Troubleshooting
- System Description
- Customize Parameters
- Operation Check
- Problem Symptoms Table
- Diagnosis System
- Terminals Of Ecu
- Diagnostic Trouble Code Chart
- Dtc Check / Clear
- Operation History List
- Open in Driver Side Electrical Antenna Circuit (B27A1)
- Open in Rear Floor Electrical Key Oscillator Circuit (B27A6)
- All Door Entry Lock/Unlock Functions do not Operate, but Wireless Functions Operate
- Open in Front Floor Electrical Key Oscillator Circuit (B27A5)
- Driver Side Door Entry Lock and Unlock Functions do not Operate
- Driver Side Door Entry Unlock Function does not Operate
- Driver Side Door Entry Lock Function does not Operate
- Entry Interior Alarm does not Sound
- Room Oscillator does not Recognize Key
- Additional Key cannot be Registered
- New Key cannot be Registered
- Entry Exterior Alarm and Answer-back Buzzer do not Sound
All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch
DESCRIPTION
The main body ECU (multiplex network body ECU) receives switch signals from the
door control switch assembly on the front passenger door and activates the door
lock motor on each door ...
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Other materials:
Installation
INSTALLATION
PROCEDURE
1. INSTALL GENERATOR ASSEMBLY
(a) Install the generator bracket to the generator assembly with the bolt.
Torque:
20 N·m {204 kgf·cm, 15 ft·lbf}
(b) Install the generator assembly with the 2 bolts.
Torque:
43 N·m {438 kgf·cm, 32 ft·lbf}
(c) Connect the generato ...
Side Airbag Sensor RH Circuit Malfunction (B1620/21)
DESCRIPTION
The side airbag sensor assembly RH consists of parts such as the safing sensor,
the diagnostic circuit and the lateral deceleration sensor.
When the airbag sensor assembly receives signals from the lateral deceleration
sensor, it determines whether or not the SRS should be activate ...
Terminals Of Ecm
TERMINALS OF ECM
1. CHECK ECM
HINT:
The standard normal voltage between each pair of ECM terminals is shown in the
table below. The appropriate conditions for checking each pair of terminals are
also indicated. The result of checks should be compared with the standard normal
voltage for t ...
