TTGuideTacoma manuals & technical reference
HomeLatestPopularManual indexSearchContacts
Toyota Tacoma (2015-2018) Service Manual / 2gr-fks Engine Control

Toyota Tacoma (2015-2018) Service Manual: 2gr-fks Engine Control

  • Accelerator Pedal
  • Air Fuel Ratio Sensor
  • Camshaft Oil Control Solenoid
    1. Components
    2. On-vehicle Inspection
    3. Inspection
    4. Removal
    5. Installation
  • Camshaft Oil Control Valve(for Exhaust Side Of Bank 1)
    1. Components
    2. On-vehicle Inspection
    3. Removal
    4. Installation
  • Camshaft Oil Control Valve(for Exhaust Side Of Bank 2)
    1. Components
    2. On-vehicle Inspection
    3. Installation
    4. Removal
  • Camshaft Oil Control Valve(for Intake Side Of Bank 1)
    1. Components
    2. On-vehicle Inspection
    3. Removal
    4. Installation
  • Camshaft Oil Control Valve(for Intake Side Of Bank 2)
    1. Components
    2. On-vehicle Inspection
    3. Removal
    4. Installation
  • Crankshaft Position Sensor
  • Ecm
  • Engine Coolant Temperature Sensor
Purge Valve
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT PURGE VSV (a) Measure the resistance according to the value(s) in the table below. Text in Illu ...

Accelerator Pedal
Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY (a) Connect the Techstream to the DLC3. (b) Turn the ...

Related Tacoma materials

System Description
SYSTEM DESCRIPTION 1. SYSTEM DESCRIPTION (a) The Electronic Controlled Automatic Transmission (ECT) is an automatic transmission that has its shift timing electronically controlled by the ECM. The ECM detects electrical signals that indicate engine and driving conditions, and controls the sh ...

Torque Converter Clutch Circuit Short to Ground (P074011)
DESCRIPTION Shift solenoid valve SL is turned on and off by signals from the ECM to control the hydraulic pressure acting on the lock-up relay valve, which then controls operation of the lock-up clutch. DTC No. DTC Detection Condition Trouble Area SA ...

Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. Turn the engine switch to the LOCK position. The fuses are located in the following places. To check the fuses, follow the instructions below. Engine comp ...

TTGuideToyota Tacoma manuals and technical documentation.
В© 2011-2026 www.ttguide.net