Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL CRANKSHAFT POSITION SENSOR
(a) Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
NOTICE:
- When reusing the crankshaft position sensor, inspect the O-ring.
- If the O-ring has scratches or cuts, replace the crankshaft position sensor.
(b) Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
(c) Connect the connector to the crankshaft position sensor.
2. INSTALL FRONT FENDER SEAL RH
HINT:
Use the same procedure as for the LH side (See page
).
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT FENDER SEAL RH
HINT:
Use the same procedure as for the LH side (See page
).
2. REMOVE CRANKSHAFT POSITION SENSOR
|
(a) Disconnect the connector from the crankshaft position sensor. |
|
(b) Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.

